VW Jetta
Door Panels and Handles
DIY Projects

How do you replace a door handle on a 1990 Volkswagen Jetta?

101112

Top Answer
User Avatar
Wiki User
2011-09-12 20:43:20
2011-09-12 20:43:20

There is a screw located in the side of the door above where the locking component is and there is another one under the middle cover in the handle This holds the whole handle assembly in place. Remove these screws (it should be a large Philips head and a small one at the front part) and try removing the handle. removal of the door panel is not necessary no rods connect it to the inner handle and stuff.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

where is located the starter at 1990 Volkswagen jetta

User Avatar

To replace the radio antenna on the 1990 Jetta you simply unscrew it (counter-clockwise) and screw the new one clock-wise. If you are replacing antenna with off the shelf product You will probably have to remove the wheel, wheel well fender protector, to have access to the bolt for the antenna

User Avatar

To replace the 1990 VW Jetta water pump you need to have a new one. By using the tools in the tool box, carefully open the old water pump and replace it with a new one.

User Avatar

Go to the library and get the manual; locate the appropriate instruction and follow it.

User Avatar

No great mystery here, pull the fuse out, if it is burned or blown replace it. If not put it back in.

User Avatar

Neville Jetta was born on 1990-02-12.

User Avatar

Check this answer Door_handle_on_1994_geo_metro_will_open_from_inside_of_car_but_not_outside

User Avatar

its in the water pump take off the power steering pump and take off the water hose

User Avatar

The switch underneath the coolant reservoir may have gone bad overtime. It is simple to replace.

User Avatar

Depends on mileage and condition.

User Avatar

how to replace a 1990 Chevy Beretta battery

User Avatar

Answer 90 oldstoronado door handle repl1990 olds toronado door handle replacement-take off the interior door panel, this will give access to the handle. there are 2, 7mm nuts on the back side of the handle. remove both, and work the handle out with a small prybar or screwdriver. careful not to bump the power lock mechanism or disconnect it.when u get the handle out of the bolt holes, reach behind it and lift the handle off the push rod that opens door. that's the best i can describe it. simply reverse to install

User Avatar

How do you replace a waterpump on a 1990 BMW 325i

User Avatar

The Volkswagen Transporter T4 was first released onto the market back in 1990. The Volkswagen Transporter T4 then ceased production 13 years later in 2003.

User Avatar

Volkswagen has a hardwired cooling system in a good number of their models, the cooling fan will run several minutes after driving. Especially if the engine is overheated, you can expect the fan to resume after it has initially shut off... So make sure to disconnect the battery before any repairs following running the engine. Brandon 1990 volkswagen jetta gl 1.86 carrat Wolfsburg edition

User Avatar

you must pull inner door panel, window crank and inner handle then you have two 10 mm nuts holding outer door hanle on you must remove the release rod from handle remove nuts and replace handle assemble in reverse order

User Avatar

The 1990 VW Jetta turn signals will not work when the ground wire is broken or corroded. The turn signals may need the lightbulb's replaced.

User Avatar

Replace the spark plugs, wires, distributor cap and spark plug wires.Chances are your vehicle is in need of a good tune-up. Mark adjust your timing

User Avatar

Where is the Water Pump located and how do you replace it on a 1990 Chevy Corsica?

User Avatar

The 1990 VW Volkswagen Jetta takes 16" or 18" wiper blades on both sides front depending on the trim level. See sources and related links below for more information. Since there are over 22 different wiper arm attachments, do not buy wipers just by length only - be sure to lookup exact wiper blade part numbers by vehicle make, model and year for the brand wiper you decide to purchase. This ensures correct length AND correct attachment.

User Avatar

1-3-4-2 Number 1 at the passenger side

User Avatar

How can one replace a cornering light on 1990 Mazda dx


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.