answersLogoWhite
Heater Cores and Blower Fans
Geo Storm

How do you replace a fan blower for AC-heater on 1990 Geo Storm?


Top Answer
User Avatar
Wiki User
2011-09-12 20:43:36
2011-09-12 20:43:36

Open passanger door, look under dash to the far right, there you will locate the fan/blower motor, it is mounted facing up. Take a Phillips screw driver or a 8 mm socket and there should be apprx. 5 screws holding it on. There is one on the back side that is a pain to get to, a short screwdriver or flexible socket may be required. Carefully let the fan down and unplug the wires. Installation is reverse of this.

Related Questions

User Avatar

To replace the heater blower motor: First unplug the wire connectors. Then remove the screws and the motor will pull out. Reverse the process to reinstall the blower motor.

User Avatar

If you are saying the Blower Motor only works on high, then your problem is a defective Blower Motor Resistor Pack. Replace it.

User Avatar

Remove the unit from the column and take it to a locksmith and have it re-keyed.

User Avatar

If you are saying that the blower motor only works on the high speed setting, then the Blower Motor Resistor is defective and needs replacing.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.