Mazda Protege
Ford Aerostar XL
Ford Ranger XLT
Chevy 350

How do you replace a freeze plug in a 1991 Mazda Protege?

353637

Top Answer
User Avatar
Wiki User
2010-12-06 23:51:09
2010-12-06 23:51:09

I have never replaced one this model but in order to change a freeze plug you really need to pull the entire engine out and usually many of the accessories on the engine in order to pull it out with a channel lock or similar tool. than simply tap a new freeze plug in.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Can someone please tell me how to hot wire the ignition of a 1991 mazda protege?

User Avatar

the clutch and the brakes share the same master cylinder on my 1991 protege dx 1.8 sohc

User Avatar

I/C regulator built inside alternator.

User Avatar

IF ITS A 1.8, THEN ITS NEXT TO THE TIMING COVER

User Avatar

6.5inches. Most modern speakers won't match up perfectly on the holes. I've owned a 1993 Mazda protege and a 1991 Mazda protege, I've changed the head unit, speakers and added an amp and sub to both, so I know =p

User Avatar

Front 5.25" @ 1.75" * Rear 5.25" @ Over 8"

User Avatar

The owners manual should have a fuse box diagram. If you don't have one, try MOTORLIT.COM

User Avatar

if you are standing on the passenger side facing the engine,it is on the lower left side.easy to change has two bolts

User Avatar

It's right there. you can't miss it, on the top right hand side of the engine block. did you look?

User Avatar

A bad battery terminal(s) connection, bad ground, bad ignition switch, bad starter.

User Avatar

in most cars, when your car dont go over about 30mph, its a trans problem.

User Avatar

See if your public library has a Chilton's for your car to replace the clutch.

User Avatar

Got the 2 bolts on the top, remove them and put the new one on

User Avatar

This is an NHTSA-listed Safety Recall item. All Mazda USA dealers are to perform this Safety Recall work free of charge for all 1990-1994 Mazda Proteges and 1990-1994 Mazda 323s, but only if indicated by either a malfuntioning driver- or passenger-side passive shoulder belt.

User Avatar

you didn't specify manual or automatic tranny but know thisstarting in 1991 ford made (in my opinion) a big mistakethey joined forces with Mazda corp. instead of a 1.9 the escortsgot the 1.8 Mazda not to mention a Mazda tranny/ suspension.by joining with Mazda all parts became much more expensive and more difficult to replace!! thanks alot japan!!! good luck with your hybrid!!!

User Avatar

how do remove the brake drum on a 1991 mazda 323

User Avatar

Mazda Navajo was created in 1991.

User Avatar

A standard 1991 Mazda 626 was originally equipped with 185/70-14 tires. A 1991 Mazda 626 Turbo came originally equipped with 195/60-15 tires.

User Avatar

Give AIDS the Freeze - 1991 is rated/received certificates of: West Germany:0

User Avatar

Replace the horn relay. Also look at the foam padding in the steering wheel,it may be worn out. My 99 escort had a stuck horn...pull out the foam switch in front of the air bag, move it around a little, clean the contacts, then test it with a multimeter to make sure it un-stuck itself. -Matt http://www.olszak.net

User Avatar

remove neg cable remove sensor that is located on top of alternator, move to one side still connected. remove power and reg cables on alt. loosen tension bolt remove bolt at bottom of alt. can do it from top behind alt. rewmove tension bolt and belt,work altr loose thru top between gas line and sensor that you moved, replace the same way

User Avatar

It is important to know as much as possible about the car that it is driven. Yes, there is a clutch adjustment on a 1991 Mazda 929.?รฆ


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.