Remove the rotor. Knock the remaining stub out with a hammer and punch. Go to a parts store and buy a new stud/w nut. Place the new stud into the hub, and draw it down tight with the nut, installed temporarily backwards.
in front of steering wheel in engine compartment ( two small caps on rectangular block )
Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.
The 1989 Oldsmobile was most definitly a front wheel drive vehicle.
Four wheel drive? 2 Wheel Drive? Front? Rear? Pads, shoes? You're going to have to be more specific.
check your struts sounds like they are worn out
5 bolt pattern
I believe it's 104.3"
All Chevrolet Celebrity cars are FWD (front wheel drive).
Do not believe there were any Dodge Spirits made until 1989! Dodge Spirits was made from 1989-1995, that's when they was replaced by the Plymouth Breeze and the Dodge Stratus.
Neither the front or rear bumper of a 1989 Chevrolet truck will fit on a 1989 Dodge truck. The bolt patterns are different and will not line up.
It's under the dash/steering wheel to the left.
the front bearings on the 1989-thru-1997 ford thunderbird/mercury cougar cannot be changed, the whole front hub comes as one piece and have to be replaced as a single unit.