1982-1994 Chevy Cavaliers

How do you replace a fuel injector on a 1992 Chevy Cavalier?

101112

Top Answer
User Avatar
Wiki User
Answered
2005-10-17 00:20:08
2005-10-17 00:20:08

remove two torx screws that hold down the bracket which hold down the injectors. then you can pry out the injector whit an screwdriver but becareful not to damage the injector or o-rings

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


how do you replace ignition switch on a 1992 Chevy cavalier 2.2 4 cylinder

Go to the auto zone for parts and instructions

i would like to remove the backseat from my 1992 chevy cavalier

In the gas tank. Costs about 300-500 dollars for a shop to replace it..

The directional flasher for a 1992 Chevy Cavalier is under the dash. It is mounted on the drivers side, beside of the steering column.

how do you replace a CV joint on a 1992 Chevy pickup?

Do you have a picture of location of crankshaft position sensor for 1992 Chevy Cavalier 2.2L ohv engine?

That is referred to as "back dating" and it is illegal at the federal level.

You can check your automatic transmission fluid in your 1992 Chevy Cavalier with the transmission dipstick. The dipstick will have marks that indicate whether it is full or low one quart.

http://wiki.answers.com/Q/How_do_you_tighten_your_alternator_belt_1992_Chevy_Cavalier"

yes it does and depending on the engine some have more then one

Knowing the firing order of a cars engine can help diagnose car problems. The firing order for a 1992 Chevy Cavalier is 1-2-3-4-5-6.

Simply remove the 4 bolts holding it on and replace it.

its located at the rear of the engine (center) attached to the block

try your chev dealer and they should be free

In the center console, below the trap door.

It will take an experience mechanic approximately 8 hours to replace the timing belt in your 1992 Chevy Corsica. The 1992 Chevy Corsica does not have each timing chain, it has a timing belt.

A fouled or worn out plug, a bad or loose plug wire. There is also a chance that internal engine damage (burnt valve), or even an injector that has quit working.

Usually in housing at engine end of upper radiator hose

Check the camshaft sensor. If the sensor is bad or not getting power, then the engine will not fire and the injector will not get a signal.

its on the passerger side by the front wheel under the power steering.

the 3.1 liter v6 and the 4 cylinder both have sepentine belts

from what i have been told that you disconnect the battery terminals and then reconnect them. that should reset the computer

Under car on frame rail near driver seat area.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.