The answer can be found at www.dippy.org. I just did this last week
The firing order for a 1985 Chrysler Fifth Avenue with a 318 c.i. engine is 18436572.
The fuel filter on a 1985 Chrysler 5th avenue should be below the alternator on the passenger side of the car
$300 - $400
15 to 18 mpg
The dash has to be removed to gain access to the heater box. The heater box then comes out and is split open to replace the core.
Get a manual on your car from AUTOBOOKSONLINE.COM.
To replace the heater core of a 1985 Bronco 2, open the glove box and push on the 2 tabs that hold it in place. After removing the entire glove box, remove the round plastic screws of the heater core. Remove the old and replace with a new one.
Remove the water supply hoses from your 1985 Chevy heater core. Remove the heater core retaining bolts. The heater core will come out. Reverse the process to install your new heater core.
depending on the accessories under the hood, it weighs approximately 3600 lbs.3300 - 3500 lbs (wikipedia.com: look up 1985 Chrysler 5th Avenue)
leaking wheel cylinder
Drivers Side, transmission below shift linkage
the belt diogram should be right there wher your latch hoock is when you open your hood
All Chrysler 5th Aves from that era had A904 3-speed auto transmissions
I had a 1983 and a 87 some parts were interchangeable
If they disconnected the heater core, it means it was leaking. Get a manual on your car from the parts store and it will show you how to replace the heater core also
get a manual on your car from DISCOUNTAUTOREPAIRMANUALS.COM and it will help on the next repair also. This is not an easy job.
more than likely 0.035 but check your local library or google since its the 21st century
It doesn't have a modulator valve.It doesn't have a modulator valve.
Diagram is located at left rear [ drivers side ] top of firewall under open hood.
The tranny is a 902 not 727 (torque flight) except I believe in an '83. about the 83 a tranny site will give that info for shure.