Heater Cores and Blower Fans
Jeep Wrangler
Ford Bronco XLT
Ford F-150

How do you replace a heater core on a 1994 Jeep Wrangler 4-cylinder without AC?

596061

Top Answer
User Avatar
Wiki User
2015-07-15 21:03:00
2015-07-15 21:03:00

you have to remove the heating unit and fan from under the dash. this is done by unbolting it from the fire wall. Be sure to bypass the heating core if you need to drive your jeep around. Then open it up a nd pop out the core. once you replace the heating core seal up the heating unit with silcon sealant. then be sure to make it fit well when you put it back in or water can come down into the the unit from the intake. also if it isn't in tight air will blow through the cracke from the engine compartment

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

I also have a 2000 jeep wrangler. This year has a problem with the heater core plugging up. You can either try to flush it out, or just replace the heater core.

User Avatar

free diagram step by step at www.jeep4x4center.com

User Avatar

The heater core is leaking. GEt a manual from DISCOUNTAUTOREPAIRMANUALS.COM and replace it.

User Avatar

It is never easy to replace a heater core. Replace it is easy, but getting access to it is never easy. But your Jeep Wrangler is one of the easier ones to replace. Just remove enough of the dash parts to gain access to the core. Be careful and remember where and how everything goes back together. Photos taken during the process with digital camera might help you remember.

User Avatar

Heater works fine in my Wrangler! Check the thermostat or the hoses or heater core might be plugged. The thermostat is easiest ^ cheapest to change so start there.

User Avatar

How do you replace the heater core on a jimmy?

User Avatar

right up under the passenger dash there is a black plastic case take of the case the motar is in there un plug it then unscrew the 4 bolts and replace

User Avatar

If your talking about the plug for the block heater, it's located in front of the battery.

User Avatar

The heater inlet hose on a 1999 Jeep Wrangler 4.0L is located in the left, rear of the engine compartment. It connects directly to the heater core which circulates heat throughout the cabin.

User Avatar

A "heater" or a "heater core"?

User Avatar

Replace it.Replace it.

User Avatar

I had one of these on a 1991 Wrangler and if I remember correctly it had 3 speeds. i currently have a 92 and it dose have 3 speeds

User Avatar

Pretty much behind the radio, but all the way to the firewall. Impossible to replace the heater core without destroying something without a proper instructional.

User Avatar

How yo take a heater core out of 2002 lincoln navigator with 5.8 engine and can you do it without removing inside dashboard?

User Avatar

The heater matrix, in a Peugeot 206, can be replaced by removing the heater core and the hoses. With the heater core removed you can replace it with a new heater core.

User Avatar

how do you replace a kerosene heater wick for a kerosun omni230 heater?

User Avatar

Yes. It has a heater core in the dash that has air blown over it to heat the passenger compartment.

User Avatar

How to replace a heater hose on a 2001 Oldsmobile silloute

User Avatar

The heater matrix can be replaced by removing the heater core and temperature control cables. Replace the heater core and the control cables.

User Avatar

In a 1997 Jeep Wrangler, the relay switch for the heater blower and motor is located behind the dash. It will be directly behind the HVAC knobs behind the dashboard.

User Avatar

how do you replace a heater core in a 91 Oldsmobile 98


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.