answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered
2008-03-14 17:56:01
2008-03-14 17:56:01

there should be little screws that you screw out and they pop out and you twist the bulb to remove it

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


A Chevy Tahoe's license plate bulb can be used to light up the license plate. In the dark the license's plate will still be visible.


How do you replace the license plate lights on a 2000 celica?



Added to that, and assuming that you're asking because your license plate light is out, and because the fuse is the same fuse for the tail lights, then the problem is not the fuse. It's the license plate light itself. === It should be the same fuse as the taillights.


I think for most cars, the license plate lamp is on the same fuse as the taillights, so if the taillights are working, and the license plate lamp isn't, check the globe or the wire


twist rubber housing a quarter turn pull out replace with new bulb


take off the license plate then screw the holder on with the plate.


Look above the license plate and find the bulb assembly, grasp the flat part turn it clockwise and pull it out, the bulb just pulls straight out.


Remove screws, remove light assembly, rotate bulb holder counterclockwise & pull out, replace bulb(# 194). Installation is reverse.....


how to replace the license plate bulb on a 2004 Honda cr-v



Yes, all cars have a license plate light. It is mandated by law.


how do you replace a honda crv licence plate bulb on a 2004


how do u change the license plate light on a 2005 sienna


yes there is, just above rear plate.


how do you replace license pate light on 2006 pontia g6


The heater core can be found behind the passenger side kick plate. Remove the water supply hoses from your 1996 Chevy Impala heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.


how to change 2005 equinox license plate light i removed the screws but it didn't release


The license plate light and connected right above the plate on a 2002 Volkswagen Beetle. To replace it just unscrew the old light and mount the new bulb.


unscrew the bulb in the opening above the rear license plate holder- bring the bulb to an auto parts dealer then replace the bulb


The license plate bulb is located right above the plate on a 2002 Oldsmobile Bravada. To replace the light simply remove the old bulb and install the new one.


Unscrew license plate and remove to expose light fixtures. Wedge light module away from holes. Replace them and return them to sockets.


A1966 Chevy Impala 4-door is 213.2-inches. It is 79.6-inches wide. Serial Numbers were stamped on a plate on the left front door hinge pillar.


To change the license plate light on a 1998 Chevy Cavalier, reach up under the bumper and remove the bulb over the license plate. Then put a new bulb in the socket. The bulb can also be accessed by removing the lens on the outside, but there are screws to remove first.


It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.