Chevy Astro
Dodge Intrepid

How do you replace a map sensor on an 1995 Chevy Astro van?

222324

Top Answer
User Avatar
Wiki User
2008-03-24 17:31:44
2008-03-24 17:31:44

easy, remove the large engine cover situaeted in the cab below the radio area, engine will be totally exposed, map sensor on rear off engine to rear of manifold opposite side to driver, jlwimports@yahoo.co.uk

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The 1995 Chevrolet Astro and coolant temperature sensor can be found on the front of the engine. The coolant temperature sensor will be a few inches above the thermostat housing.

User Avatar

engine diagram of 1995 chevy astro vas

User Avatar

The cost to replace a 1995 Chevrolet Astro van will vary depending on the labor costs and the part cost. The price for the starter starts at $46.00 dollars.

User Avatar

what is an ignition actuator i work on Chevrolet and have never heard of it are you talking about the switch

User Avatar

1995 Chevrolet Astro, 4.3 V6 engine with Single Point Injection System has one O2 sensor located in exhaust pipe (between catalitic converter and the place where exhaust pipes from right and left cylinder heads meets in one pipe).

User Avatar

Behind the wheels, attached to the axle.

User Avatar

drop the fuel tank and it's inside. remove the retainer on top then pull out the pump from the fuel tank

User Avatar

A crank sensor was not USED on a 1995 model.

User Avatar

what size of transmission goes on chevy g20 cargo van 1995

User Avatar

fuel pumps whine when they are going bad

User Avatar

`on the right side of engine in the center of engine

User Avatar

That year did not have a INTAKE AIR TEMPTURE SENSOR.

User Avatar

How do you replace a break light switch on 1995 Chevy Tahoe

User Avatar

The Fuel Tank is 27 gallons. I've had my 95 Astro van since 2000.

User Avatar

Where is oxygen sensor on 4.3 liter 1995 Chevy S10. All O2 sensors are threaded into the exhaust system at various points, and you probably have more than one sensor.

User Avatar

Chevy did not use a crankshaft sensor in 1995.If it won't fire then I would check the ignition module in the distributor and more then likey replace it. Also check the ignition coil and WIRE / coil wire.

User Avatar

That year did not use a crankshaft sensor. It used an ignition module.

User Avatar

When was the last time the ign. wires were changed?

User Avatar

The 1995 Chevy Silverado coolant sensor is located on the front of the engine. The coolant sensor will be a few inches above the thermostat housing.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.