How do you replace a rack from a 97 Plymouth breeze?
if the engine is the same as you pulled out then yes it will fit there is a slight difference between engines if you pull a 2 0 replace it with the same if the engine is the same as you pulled out then yes it will fit there is a slight difference between engines if you pull a 2 0 replace it with the same
To change the thermostat on a 1997 Plymouth Breeze 2.0, a bucket should be placed under the vehicle where the hose for the thermostat is. This will catch any leaking antifreeze. Remove the hose clamp from the top radiator hose where it connects to the engine. Note how the thermostat is positioned in the hose. Remove the old thermostat and replace with a new one. Tighten the hose clamp after reconnecting it to the motor…
97 Plymouth Breeze is showing symptoms of a blown head gasket and bad valve seals but is not overheating?
Check the engine ground before replacing parts. I have a 97 Plymouth Breeze that would not turn over, but the lights and radio worked. After replacing 4 parts (starter/solenoid, ignition switch, crank case sensor and safety switch), it turned out that the engine was not grounded properly. Once the ground was reattached correctly, car started.
I just replaced a starter on my daughter's 98 Plymouth breeze. It was upfront and very easy to do. Unscrew the bolts holding the starter. Make sure that you have your positive cable off of your battery. Unplug what I call the alligator clip from the old one and slip onto the new starter and screw the bolts back on the new starter and hookup the positive cable and crank the car. I am a…
How do you disconnect the ac compressor on a 97 Plymouth Breeze without having to buy a new compressor?
97 Plymouth breeze The alternator has a low out put. Batterie light is on. Gauges went crazy. Clock won't display. It dies when in idle. Turn signal works rarely. Lights won't work right. What is it?
Why is it that the transmission on my 97 Plymouth breeze will slip or not go when you put in drive or reverse sometimes but then the engine revs and jolts forward when the tranny catches?
If this is a 4-cyl, it is a very in-depth process to replace the seal...removing motor mounts and the majority of engine components to be able to pull the camshaft. If it is necessary, follow instructions for replacing the head gasket on your model. You can replace the seal at the point of removing the Timing Belt.