answersLogoWhite
Ask
Toyota Corolla

How do you replace a rear wheel bearing on a 1997 Toyota Corolla?

505152
Answer

Top Answer
User Avatar
Wiki User
2015-07-15 21:06:24
2015-07-15 21:06:24

first remove hubcap (if any) then remove the wheel. remove the drum, and you will see the hub/bearing unit, it should be bought at a Toyota dealer as a whole kinda pricey, but always try to stay with OEM. look behind the hub and as you turn the hub(where the 4 lugs are) you will see 4 other 14mm bolts on the black backing plate. remove them and it should come out. if not, a little tap with a rubber mallet will do the trick. the 2 holes on top are spaced further than the 2 bottom holes, so careful while installing. hand tighten all bolts first then tighten to specs. good luck

1
0

Related Questions

User Avatar

Remove the tire and wheel from your 1989 Toyota Corolla. Remove the end of the axle. Remove the axle seal. Remove the wheel bearing. Reverse the process to install your new wheel bearing.

User Avatar

The cost to replace the wheel bearing on one side in the front of a 1996 Toyota Corolla will cost approximately $316 to $403 for labor. The cost for the parts are estimated to be $77 to $105.

User Avatar

Is the wheel bearing on the front or the rear ????.. There is a big difference ...


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.