Jeep Grand Cherokee Limited

How do you replace a rear wiper motor on a 1999 Jeep Grand Cherokee?

282930

Top Answer
User Avatar
Wiki User
2008-05-05 07:41:50
2008-05-05 07:41:50

I just replace my rear wiper motor. It is fairly simple once you get the molding off the inside of the lift gate. First remove the wiper off the rear window, then cautiously pop the collar off which will allow you to get to the required nut. After that carefully pry the interior plastic molding off, then you must peel back the factory plastic sheeting. Then just remove the motor the two bolts are fairly easy to locate, you might just have to move a few wires around to get a wrench on them. Good Luck!!

12
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

how do you get to and replace the wiper moter on a 97 marquis

User Avatar

The number six fuse controls the rear wiper motor in your 1998 Jeep Grand Cherokee. The number six fuse will be in the first column, fourth from the bottom.

User Avatar

If the wiper motor is good and the motor shaft turns when the wiper is on then you need to check the linkage for the wiper arm. the rear wiper motors and switches are notorious for going bad in the jgc you may have lost your switch.

User Avatar

You will need to take out the whole motor to replace it. It is usually best to get a mechanic to take care of it.

User Avatar

remove the wiper arms, remove the cowl covers, remove the cowl assembly, that is, the big plastic thing that the wiper motoe sits in. It is held is with about five or six 8mm bolts. Unplug the wiper motor and turn the assembly upside-down to access and replace the wiper motor.

User Avatar

where is the location wiper motor Pontiac grand prix 2002

User Avatar

Where is the windshield wiper relay located on a 1996 grand jeep Cherokee

User Avatar

How to replace wiper motor on a 1998 montero sport mitsubishi

User Avatar

how do you replace rear wiper motor on a 1997 ford explorer

User Avatar

Remove the wiring harness from the wiper motor. Remove the windshield wiper arm from the wiper motor. Remove the wiper motor retaining screws. Reverse the process to install the new wiper motor.

User Avatar

The 1994 Jeep Grand Cherokee takes 20" replacement windshield wiper blades on both sides front and a 10" or 11" wiper on the rear.

User Avatar

Remove the wiper arm from the wiper motor. Remove the wiring harness. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.

User Avatar

how do you replace a wiper motor in a 2000 jetta?

User Avatar

where is the wiper motor on a 1996 Nissan Maxima GXE

User Avatar

Remove the wiper arm from your 1999 Oldsmobile Cutlass wiper motor. Remove the wiper motor wiring harness. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.

User Avatar

The 1993 Jeep Grand Cherokee takes 20" replacement windshield wiper blades on both sides front and an 11" or 12" rear wiper blade.

User Avatar

You will have to remove the wiper arms, then remove the cowl, and then the wiper motor.

User Avatar

Remove the 2005 Honda Odyssey rear wiper arm from the wiper motor. Remove the wiring harness from the wiper motor. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.

User Avatar

Remove the wiring harness from the wiper motor. Remove the wiper arm linkage. Remove the wiper motor retaining bolts. Reverse the process to install the new wiper motor.

User Avatar

how do you replace the wiper motor pulse board on a 1999 Chevy Silverado 2500

User Avatar

Replace wiper motor with a new one. Do not install a rebuilt motor on this vehicle.

User Avatar

http://www.ehow.com/video_4936070_install-windshield-wiper-motor.html?pid=1&cp=1 (this is very informative video on how to remove and replace a windshield wiper motor)


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.