Dodge did not make a 1996 Dynasty. The last Dynasty was built in 1993.
Try this site! Hope it helps you!http://www.mvreader.com/multiview/dayco/catalogSearch.php?autoCatalogSearch=1&make=DODGE&model=DYNASTY&year=1993&year_from=&year_to=&engine=BAR&l=
Loosen the tensioning pulley and install new belt. There should be a routing diagram in engine compartment or on hood.
Underneith the Dash.
change wiper switch
Spring into the engine.
The Dodge Dynasty was produced from the years 1988 to 1993. The wiring harness from the fuel pump to the battery in a 1989 Dodge Dynasty is located very close to the battery terminals.
On a 1993 Dynasty, it's on the engine compartment right front fender well.
allpar.com this site is for mopar ( Chrysler , dodge etc.) excellent site
i dont know im not a car expert.
O,YEA AND I FORGOT TO MENTION IT IS A 1993 DODGE INTREPID...
With filter the capacity is 4.6 quarts.
1993 Dynasty (irregardless of motor) will fire 1-2-3-4-5-6 with a counterclockwise distributor motion if it's the 3.0L. The cylinder block as you look at it from the front of the car is: _____________ | | | 1 3 5 | --------------- | 2 4 6 | |_____________|
how to replace steering rack in 1993 dodge intireped
as long as the marker lights are the same ( some years don't have them ) i not sure which ones , Chrysler made all the dynasty bodies the same , you should be able to interchange most of them.
the front are 5.25 inches and the rears are 6x9s
Body Control Module(BCM) is located inside kickboard(passenger side)
Dodge doesn't use an inertia switch. It controls the fuel pump via a pcm actuated relay.
The fan sending unit is on the side near the thermostat housing.
Located in fuel tank - may have to remove for access
Should be under the car just ahead of the passenger rear wheel