1995-1999 Dodge & Plymouth Neons
Pontiac Bonneville
DIY Projects

How do you replace a starter in a 1993 Pontiac Bonneville SE and how many bolts need to be removed?


Top Answer
User Avatar
Wiki User
2015-07-15 19:58:56
2015-07-15 19:58:56

hey , well open the hood , disconnect the battery .get uder the front of the vehicle. you should know what a starter looks like ........ theres a small bolt holding the wire and a dirt protector that must come off first. then you'll be able to access the two 15mm bolts , you'll need a socket extention to reach the one in the back. their parralel to each other/ front bolt back bolt/ then a 5/8 socket to remove the feed wire from the battery to the starter unit and i think a 1/4" to remove the smaller terminal screw. take care in removing, there's a little bit of a shift and twist to get it out- remember too that you need to check both pos n neg wire connections to the batery, clean them and also check continuity of cables.... good luck. takes me about 15-20 mins to remove


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.