GM and GMC

How do you replace a starter in a 1995 GMC S1500 extended cab pickup?

464748

Top Answer
User Avatar
Wiki User
2015-07-15 19:17:09
2015-07-15 19:17:09

First, remove the negative battery cable. Then remove the wires off of the starter. Then remove the 3 bolts that hold the starter on and work it out around the exhaust.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The Fujifilm is known for its great stabilization, but the Canon is a better all-around camera.

User Avatar

It is located on the driver side exhust pipe next to the manifold pointed twards the cab or the transmission

User Avatar

mostlikley your blocked is cracked from excessive overheating I had the overheating problem on a 1986 Honda Civic SI and a mechanic tell me to buy a new radiator cap before we do anything else since it had the original radiator cap. I replace it and it has never overheated again. You probably have a faulty water pump.....With the age of the car, i think its high time to replace it and the timing belt as well...... Ditto on the last two answers. I'd try having the system pressure tested. This is an inexpensive service at most shops. A new cap is cheap insurance. If the water pump is going bad, it may begin to leak and/or make noise. If you're close to needing a timing belt change, go ahead and replace the pump. Try the pressure test and new cap first...MUCH cheaper.

User Avatar

not sure but check the left side of the tranny and there maybe a cable hooked to the shift arm that goes to the steering column that locks the key in the on posistion !!!! if so unhook it from the trans. and push the arm up on the column hopefuly that will solve it !!!!!!!!!!!

User Avatar

You'll need a set of pliers designed to remove the ignition wire boots from the spark plugs. Any auto parts store should have them. You'll also want a 3/8 socket wrench handle, various lengths of extensions and a universal joint to help you get into the tight spots. Wrap the universal joint with a couple of turns of electrical tape. The will take the "floppiness" out of it and will allow you to more easily get the socket on target without a lot of fumbling and swearing. Of course, you'll also want a spark plug socket for your type of plugs as well as a packet of anti seize compound and a spark plug gaping tool. Your auto parts store can help get you properly supplied.

User Avatar

How do you replace a starter in a 1997 F-350 Turbo Pickup?

User Avatar

disconnect the battery, un bolt the starter and replace it then connect the battery

User Avatar

Your starter solenoid is sticking. Replace the starter solenoid and you should be good to go.

User Avatar

What year,what motor?? it is a 2002 Chevy avalanche 1500

User Avatar

Remove the positive battery cable from your 1988 Chevrolet 1500 pickup truck battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

User Avatar

Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter

User Avatar

Disconnect the - battery cable Raise and support vehicle Remove wiring at top of starter Remove starter mounting bolts Remove starter

User Avatar

Usually it's attached to the starter. Imagine two cans of beer, a 16oz and a 12oz, tape them together and you got the starter and starter solenoid. If someone told you to replace that, you should replace the starter because they cost just about the same.

User Avatar

Remove - battery cable Raise and support vehicle Disconnect wiring at top of starter Remove starter mounting bolts Remove starter

User Avatar

Disconnect the - battery cable Raise and support the vehicle Remove wiring at the top of starter Remove mounting bolts Remove starter

User Avatar

Assuming you are referring to the starter solenoid which is on... the starter. In fact, it's a part of the starter. If the solenoid goes bad just replace the entire starter, the whole thing is probably worn out anyway.

User Avatar

on the right side of the pickup get on the ground in look up the starter is about 6 inches long make sure toremove both battier cables before removing the starting.. two 14mm one top one bottom

User Avatar

I need to replace the starter in a 2003 Tundra, but where is it the starter? I need to replace the starter in a 2003 Tundra, but where is it the starter?

User Avatar

The starter relay can be found underneath the hood on a 1991 Nissan pickup. The starter relay is beside the battery on the passenger side.

User Avatar

The 1994 Toyota pickup truck starter mounting bolts can be found on the head of the starter. There will be three mounting bolts.

User Avatar

Most Ford trucks are the same. First thing you do, is disconnect the battery cables. Then get underneath the truck, disconnect the negative cable from the starter. Remove the 2 bolts holding the starter. Remove, and replace the starter, and reconnect the negative cable to the starter, then reconnect your battery.

User Avatar

Need to know what size engine you have in order to answer your starter problem. 1993 Nissan pickup with v-6


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.