Take the neg battery cable off. Then the wires off of the starter then the bolts that hold it on. Then sometimes you have to remove th exhaust manifold to get it out.
you don't have to remove manifold just the 3 bolts holding the pipe to the manifold then cut the 2 bolts off the flanged conn. next to the flex loint ( this is from a 99 4x4 hope its the same ) manifold pipe bolts are self locking and very tight you have to glow (torches) them always remember fire bad should be done by someone experienced. cut the rear weld nuts off the flange. if you complete this and don't burn the truck up you need to check the flange at manifold make sure it good and clean joining surfaces at rear flange buy new nuts for manifold and new nuts and washers for rear flange i reused old gaskets they were fine
Go how to change a starter on a 92 Isuzu rodeo in this forum for a more detailed explanation of this process !
Hi, How Do You Replace a Starter on a 1995 Isuzu Rodeo, V6, 3.2 liter engine? Does anyone know where the starter is? Help. How Do You Replace a Starter on a 1995 Isuzu Rodeo, automatic, 4wd, V6, 3.2 liter engine? Does anyone know where the starter is? Thanks alot.
replace stop light switch
where is the pcv valve located on a 1995 Isuzu rodeo v6 3.2l
Remove beltUnbolt tensioner and remove
How do you adjust the valves on a 1995 isuzu Rodeo 3.2
Hello... what is the original size of the muffler that came with a 1995 Isuzu Rodeo lengh etc...
On the left
www.tirerack.com
Take old spark plugs out put new spark plugs in
it takes 3.2L
it will fit but you will have to get new hoses for the correct sizes
The diagnostic port on a 1995 Isuzu Rodeo drive is located on the lower kick panel on the driver's side. It is just below the left spark plug.