Oldsmobile Ciera

How do you replace a starter on a 85 cutlass?

001

Top Answer
User Avatar
Wiki User
Answered
2014-06-27 22:43:10
2014-06-27 22:43:10

The starter on a 85 Cutlass is replaced by disconnecting the battery, unbolting the starter, disconnecting the wires at the starter, and removing it from the vehicle. The new starter is then wired up and bolted to the engine block.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


how do you replace a starter on a 1998 cutlass


Stick the starter in the cutlass supreme.


Disconnect the - battery cableRaise and support vehicleDisconnect wiring at top of starterRemove starter mounting boltsRemove starter


Disconnect the - battery cable Raise and support vehicle Disconnect wiring at top of starter Remove mounting bolts Remove starter


The starter will cost you around $85. The labor will be another $75.


This is an interesting question! We've notified our experts in this category and we'll email you when there is a response.



You start by disconecting the negative - battery terminal. climb undre the car and dixconect the 2 whires going to the starter. Then unbolt the starter from the transmission. replace is the same way, just oppisite. If you don't even know where the starter is than, follow the positive battery cable till it stops. that is the starter.



How do you replace a axle on a 95 holds cutlass supreme


The starter on a 98 Oldsmobile Cutlass is located on the bottom, left side of the engine. It is held in place by a support bracket and bolts.


I need to replace the starter in a 2003 Tundra, but where is it the starter? I need to replace the starter in a 2003 Tundra, but where is it the starter?


how do i replace the bendix drive in my 85 harley fxrs


The price of the starter at most Auto Parts stores will be around $125. The labor cost will be around $85. If you get it at a Honda dealer you can double the cost of the starter.


The 1992 Oldsmobile Cutlass Supreme 3.1 liter engine starter is located on the bottom of the engine near the back. You can follow the positive battery cable directly to the starter.



yes you can, you will need new motor mounts and have to go with a HEI distriburetor so you can eliminate the computer.


The starter is located beside the oil pan on the driver's side.


follow the positive battery cable to the starter solenoid. there's three wires and two 8mm bolts. disconnect the negative battery cable then replace the solenoid by transferring the wires from the old to the new


The starter on a 1994 Oldsmobile Cutlass Ciera is located on the driver's side of the engine towards the bottom of the engine. It is behind the crankshaft sensor and the fusible links.




How do you replace a starter on 2003 powerstroke


Starter is always going to be on the bottom rear of the engine connected to the flywheel.


Remove the starter and take it to an auto parts store. They have the equipment to test it.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.