You gotta use tools.
the cam sensor is located in the timing cover usually the magnet the cam sensor senses comes out of the timing gear the fix is replace the timing chain and gear take the sensor out and look through the hole with a mirror while turning the engine over slowly by hand and see if the magnet is gone
The light bulb or the taillight lens? Open the trunk to replace the bulb.
You don't. That is a ripoff. Testing and replace out of range sensors is a more reasoable projct.
Fuse 17 in a 1993 delta 88 Oldsmobile controls the air conditioner
Only if you replace the Dryer, install adapters on the lines, and use compatible oil.
I have a Delta 88 and its located about 18 inches in front of the rear tire on the driver side, its right under the second door of the driver side.
Dont go to this
About a hundred bucks if you have someone that can do it for you! Mine just died too!
The correct tire size for a convertible 1972 Oldsmobile Delta 88 Royale is 225/75 R15.
on a 90 olds 88 royale your sensor sits inside the timing cover...will need to remove the harmonic balancer (need pulley for that) and remove two screws to take sensor out. replace all parts same way they came out and in same order. passenger side of engine in timing cover
A motor from a 1991 Oldsmobile will fit into a 1996 Oldsmobile Delta 88. The motor mounts will need to be changed.
If the delta magnetic starter pulls in then there is a problem in the delta windings of the motor. If the magnetic starter does not pull in then there is a problem in the star delta timing relay. Check the timer relay for voltage output to the delta magnetic after the completion of the timing interval.
You replace the spring and caps washers as you would in a Delta faucet
you have a sensor problem.
Depends on the engine
120 hp is the power of the Oldsmobile delta 88 automatic 1974 engine and its maximum speed is 93 mph.
It is necessary to know the fuel tank capacity of a vehicle. The fuel tank capacity of a 1968 Oldsmobile Delta 88 is 20 gallons.
bottom front of engine