Ford Windstar
Chevy Lumina
Turn Signals and Hazard Lights

How do you replace a turn single switch in a 1996 Chevy Lumina LS with a air bag the only why the blinker works is if you hold the switch?

242526

Top Answer
User Avatar
Wiki User
2011-09-12 20:47:48
2011-09-12 20:47:48

Its a tough job that requires special tools. Remove the air bag. Remove the steering with a steering wheel puller. Remove the air bag position sensor. The steering wheel lock plate needs to be removed with a steering wheel lock plate puller. Then the turn signal switch can be removed by snaking the wire harness through the steering column. Not as easy as it sounds.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

the blinker switch shorted out the brake lights... really really common problem, need to replace the switch

User Avatar

The blinker relay is broken. It is located inside the hazard switch. Replace the switch and it will fix your problem.

User Avatar

Hi, Is your blinker actually flashing on and off? If not it may be your hazard switch. I had to replace mine.

User Avatar

To replace a turn signal switch in a 1993 Chevy Lumina go to the trunk of the vehicle and find the plastic covering for the turn signal. Remove the cover and replace the bulb.

User Avatar

probably your blinker switch (multi-accessory switch). The high mount brake light is wired directly from the switch on the pedal but the rear two lights are wired through the pedal switch and then through the the blinker switch on the steering column. Almost all of those blinker switches go bad.

User Avatar

replace a windshield wiper switch on a 1995 chevy lumina van

User Avatar

its the hazard switch, its all one unit

User Avatar

the relay is located within the hazzard flasher switch. If faulty replace flasher switch and it will sort out the problem

User Avatar

your problem could be in the switch its self. unfortunetly they are expensive to replace, i had to actually wire a switch direct to the blinker system.

User Avatar

Try and replace the blinker switch. Iits a round thing under the dashboard on the fuse panel. It should be clearly marked.

User Avatar

To change the blinker switch on a 1998 Tahoe, locate the blinker switch under the dash on the driver's side. Pull it out of the socket and insert a new one.

User Avatar

Blinker switch defective. This is not always the case. You could have one of many problems. Flasher bad, bad bulb, bad connections.....please check these before you go and replace a blinker switch.

User Avatar

The Chevy lumina does not have an inertia switch.

User Avatar

blinker switch is part of that system is most likey problem trust me i owned 9 s10 all 82-94 and college for 5 years of elec/auto replace the blinker switch on the clolume"

User Avatar

I need a Diagram for a 1995 Chevy Lumina iginition switch??

User Avatar

The blinker switch is located to the left of the steering column. It is bolted up behind the dash board. It is not with the fuse box.

User Avatar

does the 1998 Chevy lumina have a fuel shut off switch

User Avatar

in the fuse box,if you mean the blinker relay.

User Avatar

The 2002 Monte Carlo blinker flasher relay switch is located beneath the drivers side dashboard. The blinker flasher relay switch will be above the brake pedal.

User Avatar

IGNITION ? ARE we talking ignition coil-ignition wires ignition switch-key & tumbler.

User Avatar

it is located at the top off the brake pedal with the brake switch. just had to replace one.

User Avatar

A turn signal not working on a 92 Chevy Lumina may be out because of a burnt out bulb. If you replace the bulb and it is still not working, the turn signal switch may need to be replaced. You can get the switch replaced by a mechanic.

User Avatar

the blinker relay is behind the glove box


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.