Hey having the same problem. I have no clue what i am doing but this web site has helped me maybe it can help you. http://www.cherokee-Jeep.com/1-2swremov.htm good luck
I assume you mean the valve cover gasket. You replace it by removing the valve cover and cleaning off the oil gasket and the mounting surface. The install the new gasket and reinstall the valve cover. Tighten it to the specifications the manufacture of your engine recommends.
The valve cover gasket, on a 2004 Jeep liberty, can be found by removing the valve cover. Peel the gasket off of the head and replace with a new gasket.
how do you replace the valve cover gasket on a 2002 mitubishi lancer
What is a oil cover
The valve cover ask it, on a S 40 Volvo, can be replaced by first removing the valve cover. Remove the old gasket and replace with a new gasket.
simply remove the valve cover gasket,take the old one off,clean the area well, and replace the gasket,tighten the cover evenly.(if ur gasket is made of corque take care not to break the gasket
how to replace valve cover gasket toyota rav4 2001
how do you change valve cover gasket 2004 hyundai elantra
How much does it cost parts and labor to replace a valve cover gasket on a 1990 Honda Accord 4door.
To replace the valve cover, you will need to break the gasket and the o-rings. The gasket prevents oil from leaking.
To replace the valve cover gaskets on a 2003 Jeep Liberty, the valve cover is removed. The old gasket is then removed from both the valve cover and the manifold (old gasket will come off in pieces on both sides). Then spread the sealant on the manifold, place the new gasket on, then put sealant on top of the gasket and replace the valve cover and bolt down.
see this site. www.ehow.com/how_4507846_replace-valve-cover-gasket-toyota.html - 51k -
take off valve cover throw away old gasket replace old gasket with new put valve cover back on pwn
you mean a valve cover gasket i think
Begin by removing the valve cover from your 1995 Dodge. Remove the valve cover gasket and clean the surface. Put the new gasket on and return the valve cover to its original position.
you should only change the gasket if you have to take the valve cover off....... you should only change the gasket if you have to take the valve cover off.......
I have a 2007 ford escape, replaced a valve cover gasket in August 2012, noticed that i have a small oil leak around the gasket.
Begin by removing the valve cover retaining bolts. Remove the old belt cover gasket and clean the surface. Put the new valve cover gasket on and reverse the process.
It's fairly simple. There should be one air line plugged into the valve cover that just pulls out, then you remove the bolts holding the valve cover on. Scrap off the old gasket being sure not to get a bunch of little pieces into the valves or valve springs, put the new gasket and the valve cover back on. The bolts should be tightened in a pattern similar to a tire but be sure you do not tighten them much. Just snug the bolts up evenly. Re-insert the air line and your good to go.
just remove the 3 bolts on top of the valve cover and lift it out,and theres the gasket.
2006 valve cover. Gasket ford freestar 4.2 l
Only when it is leaking.
ondo valve cover, bolts remove valve cover, remove old gasket from valve cover and block. clean both surfaces well. put gasket glue on one side of gasket and install on cylinder head. align valve cover than replace bolts . tighten in a cross pattern until thet are snug. don't overtighten.
Just reverse the way you took it off 'except' make sure there's no gasket material left on the seating surface and the gasket is in excellent condition on the valve cover. If you have any doubt replace the gasket. Cheers