Remove serpentine belt
Remove any components obstructing any bolts on water pump
Ensure coolant cach container is in position because your engine coolant will come out
Remove any hoses from pump (if they are stuck on you can stick something under where hose attaches to pump and this will help fee up the seal). You may also have to remove pulley (easier to loosen bolts while serpentine belt is on).
Make sure bolts are re-installed in same position (you can put them in bolt holes of new pump then swap them to old pump before installing new part).
After removing pump (you may need to pry old pump off) clean all old gasket material off engine mating surface (scraper, flat screwdriver, die grinder are all tools that can be used).
Use brake cleaner on both engine and new pump mating surfaces to ensure they are clean, then use black silicone (or equal sealant) on both the engine and new pump (both sides of gasket).
After applying silicone install new pump on engine and place bolts in to hold it in position
Install bolts hand tight
USE PROPER TORQUE SEQUENCE AND SPEC TO TIGHTEN BOLTS- DO NOT OVER TIGHTEN BOLTS BECAUSE IT CAN DAMAGE GASKET.
Re-install all other parts and properly fill cooling system.
Only the Olds Intrigue with the 3.5 L
$500
attached to the engine near the flywheel You have to go under the car. toward the back of the engine.
pour it in through the dipstick tube
you cant, your car is a write-off. Sorry.
Can anyone please tell me where the ignition switch is located on a 2000 oldsmobile silhouette?
No
Follow the top radiator hose down to the engine. It is in the water outlet.
25 gallons
if you need mean an amp for a stereo ? yes you can
all the messages are showing up on my 2000 olds silhoutte, why does it do this
1998, 1999, 2000 are interchangeable as well as the same parts from a Venture and a Montana. Same thing, different vehicle.
Facing the front of the car, the water pump is on the left front of the engine. It is to the right of the battery. You can trace the hoses coming out of it if you lift the wiring harness.
There are actually two oxygen sensors on a 2000 Oldsmobile Silhouette. There is one located in the exhaust system just before the catalytic converter. There is also another oxygen sensor in the air intake tube leading from the air filter.
Replace it with a Ford!
it is on the passenger side at the front under the hood next to radiator
GM vehicles are not equipped with a fuel pump inertia switch.