Brakes and Tires
Toyota Sienna
Honda Civic EX
1995-2005 Chevy Cavaliers

How do you replace a wheel bearing on a 98 Toyota Sienna and do you need special tools?

828384

Top Answer
User Avatar
Wiki User
2015-07-15 21:17:56
2015-07-15 21:17:56

Usually you have to pull the brake assy off then the brake disk and the small cap in the center of the axle. There will be a large nut under it that needs to be removed. This will give you access to the wheel bearings in front.

ed724

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Is the wheel bearing on the front or the rear ????.. There is a big difference ...

User Avatar

How to replace a starter in a 2009 toyota sienna

User Avatar

You replace 2002 Toyota sienna fuel pump by contacting a person who knows how to replace it efficiently.

User Avatar

how to replacemotor mount toyota sienna 2004

User Avatar

fly around car couple of times... helps alot. i am an expert in this...

User Avatar

"How do you replace a factory antenna on a 2002 Toyota Sienna?" I am talking about the whole assembly. Thanks

User Avatar

How much does it cost to replace the catalytic converter on a 1999 Toyota Tacoma

User Avatar

The cost of a windshield washer reservoir for a Sienna is 200.00 from Toyota. Copy!

User Avatar

The passenger side mirror on a 2001 Toyota Sienna is mounted by screws. To replace the mirror remove the mounting screws and unplug the wire clip.

User Avatar

The timing of a 2004 Toyota Sienna should at approximately 75,000 miles. Failure to replace the timing belt at the appropriate time can result in costly engine failure.

User Avatar

how do u change the license plate light on a 2005 sienna

User Avatar

Remove engine and transaxle assembly

User Avatar

how much does it cost to replace the timing belt in a 1998 Toyota sienna.

User Avatar

where is the classis location for toyota sienna

User Avatar

check out this website it tells you how to repair the handle since it cost about $65.00 to buy a new one. http://www.findonefindall.com/toyota-sienna/

User Avatar

To replace the front speakers in a Toyota Sienna the door panels must first be removed. With the door panels removed the speakers will be easily accessible and the mounting screws can be loosen. Unplug the speakers and remove them. Install the new speakers.

User Avatar

The 2001 Toyota Sienna has a V6 engine.

User Avatar

The 2008 Toyota Sienna has 24 valves.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.