answersLogoWhite
EGR Systems
Chrysler Town and Country
Ford F-150

How do you replace an EGR valve on a 1999 Chrysler Town and Country with a 3.8l engine?

474849

Top Answer
User Avatar
Wiki User
2015-07-15 20:08:17
2015-07-15 20:08:17

Well it's located on the side of the throttle body first off. It has two bolts and 3 vacuum lines. One thing I found when I had low power is I inspected the vac lines and found tiny cracks on them. JFYI.

It's simple to change really, if you buy a new one 60 bucks at NAPA it will come with a new gasket. Takes about 10 minutes.

1

Related Questions

User Avatar

The EGR valve on your 2002 Chrysler Town and Country can be found attached to the firewall in the engine compartment. The EGR valve will be on the drivers side of the firewall.

User Avatar

It is on the top center of the rear valve cover.

User Avatar

The EGR valve on a 2006 Chrysler Town and Country is on the top, front, passenger side of the engine. It is just above the alternator.

User Avatar

The EGR valve is on the front passenger side corner of the engine.

User Avatar

the pcv valve is in the middle of the inside valve cover wich will be called the riht side valve cover

User Avatar

On the 3.8L it is above the alternator on the passenger front of the engine.

User Avatar

The egr valve on a Chrysler Pacifica is on the front of the engine. It is near the top, behind the water pump.

User Avatar

The EGR position sensor is on the top of the EGR valve. The valve is on the front, passenger side of the engine.

User Avatar

Technically no, but I have seen valve hit valve when the timing belt breaks.

User Avatar

A Chrysler Town and Country does not have a water flow valve. The cabin temperature is controlled by a airflow door inside the dash.

User Avatar

The pcv valve on a 2005 Chrysler Town and Country is on the top of the rear valve cover.

User Avatar

This transmission does not have a modulator valve.This transmission does not have a modulator valve.

User Avatar

It is in the center of the rear valve cover.

User Avatar

It is in the center of the rear valve cover.

User Avatar

The Chrysler Town and Country PCV valve can be found on the outside of the air cleaner housing. The PCV valve will be attached to the back of the air cleaner housing.

User Avatar

The egr position sensor is on the egr valve which is above the alternator on the passenger side of the engine.

User Avatar

Yes, it is on the center of the rear valve cover.

User Avatar

The Chrysler Sebring knock sensor is located in the engine valve or cylinder located at the back of the motor. This part is in this position next to the engine valve so the sensor can feel the vibration of the engine.

User Avatar

It is located on the rear valve cover to the rear of the alternator

User Avatar

It is inside the valve body, inside the transmission.

User Avatar

Hi, assuming your Lebaron has the 3.0 engine, the pcv valve is located right behind the valve cover that faces you looking at the engine. It's toward the right side. It's threaded into the block and there will be a black tube coming out of it. Very easy to remove and replace. rtalk7


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.