Remove the wiring harness from your 2000 Dodge Stratus EGR valve. Remove the EGR valve retaining screws. Reverse the process to install the new EGR valve.
A 2002 Dodge Stratus with a 2.7 liter engine does require an EGR valve. This valve can be found near the top of the engine.
where is the thermostat located on a 1995 dodge stratus? 2.4l 24 valve. v6 engine
Yes, it is the square item on top of the valve cover.
On the egr valve.
Look on your exhaust manifold on the back side of the engine for a tube running to a valve with a sensor and vacuum line
Schrader valves are the type of valve you fill the tires through, so they're found at the wheels.
The 1999 Dodge Stratus PCM valve can be found on the outside of the air cleaner housing. The PCM valve is located on the back of the housing.
Valve to piston, no. Valve to valve, yes.
it could be your EGR valve.
replace egr valve.
A person should know the location of all the parts in their car. The Purge Control Valve is located towards the front of the engine, on the passenger side.
Remove the cap on the valve cover and pour it in there.
What size motor 2.4, 2.7, 3.0 ?
Oil pan level, front of engine.Oil pan level, front of engine.
No he is referring to the vent valve for evaporative emissions (fuel tank vapor). Your PCV is for the engine and located in the valve cover. Evap repairs are tricky and require special tools. In this case, have a professional repair it so he will be responsible for the warranty.
A 1999 Dodge Ram does not have a water control valve.
Trouble code P0403 means: Exhaust Gas Recirculation Control Circuit Replace the EGR valve
the egr valve is located between the engine and fire wall, drivers side. Just follow the metal pipes that are attached to both sides of the upper intake manifold
The 1998 Dodge Grand Caravan 3.8 liter engine EGR valve can be found on the top of the engine. The EGR valve will be near the back of the engine.
you can find it in a auto book at auto zone.
The Fuel filter is above the gas tank.
Yes, it can bend valves when a timing belt breaks.
If the light is on, it will need checked and diagnosed.
Replace if failed.
According to allpar's writeup on the 2.4 engine the tops of the pistons are cut to allow for valve clearance should the timing belt brake. Therefore it is a non- interference engne.