first disconnect the battery from the vehicle. next take plastic cover off from the passenger side floor board. next loosen the bolt on the plug connected to the ecu. next pull the ecu from the compartment.
what year? Are you talking about the ecu? I am looking for the coolant temperature sensor on a 2001 ford mustang 3.8.
2001 mustang gt ,ecu where is located?
You need an auto locksmith that can input commands to ECU
How do you replace the Catalytic converter on a 1991 Suburu Legacy L station wagon? Where I get the used parts?
The easiest way would be to get an entire wiring harness/ECU from the 1994 and put it into the 1988 with the motor. This will eliminate any splicing or cutting you may need to do otherwise.
Yes, you can. That is a relatively easy swap, it helps to have the ECU (computer) and transmission from the donor car as well. It is best to use motor mounts that fit the body instead of the motor however.
It means the ECU has detected a problem with the emissions system.
you need a mobile auto locksmith off craigslist. There are very few parts to the system outside ecu and they can test or replace them all-chipped key, halo around ig switch, module in dash
It's on the front passenger floor board....Disconnect Negative battery terminal. Remove the carpet from the top. Remove the ECU cover. Remove the ECU retaing screws. Disconnect the connector and pull out the ECU..........Installation in reverse.....
where is the ecu located on a 97 ford probe
ecu?
Either behind the factory radio or under the passenger side kick panel