Starters and Ignition Systems
Chevy Monte Carlo
Ford F-150

How do you replace an ignition switch on a 1973 Monte Carlo?

151617

Top Answer
User Avatar
Wiki User
Answered
2012-01-04 14:58:49
2012-01-04 14:58:49

This is something that should be handled by an expert mechanic. The ignition switch is a very delicate part of your car, one mess up and you might not be able to start it again.

001
๐ŸŽƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Related Questions


you will have to replace the complete ignition switch with a new one.


Begin by removing the retaining ring at the top of your 2001 Chevrolet Monte Carlo ignition switch. The ignition switch barrel will slide out. Remove the wiring harness from the end of the ignition switch. Reverse the process to install your new ignition switch.


You can remove the ignition switch, on your 1981, Monte Carlo, by removing the retaining clip. With the retaining clip removed, whole the switch out and remove the wiring.


how to ,reprogram the ignition switch on a 2001 Monte Carlo ls


You need to be clear as to what you are asking. There ire numerous parts to an ignition. Are you referring to the switch or module? jd


You can get the ignition switch dash cover for the 2003 Monte Carlo at places like Auto Zone. You can also find this item online at AutoSport Catalog or on Ebay.


Changing the brake light switch in your Chevrolet Monte Carlo is quite simple. The brake light switch simply plugs in and out.


how do i change a ignition cylinder on a 01 Monte Carlo


The 2001 Monte Carlo emergency flasher relay switch and the turn signal flasher relay switch are the same. The flasher relay switch simply plugs in and out.


You're going to have to unbolt the steering column and drop it down. The ignition switch will be on the top of the column along with your high beam switch. Unbolt the switch then unplug it.


where is the oil pressure switch located on a 2004 monte carlo


When changing anything on a car, a person needs a diagram. A person can get an ignition switch diagram for this car, by buying the cars maintenance manual.


How do i replace the purge valve on a 1999 Chevy Monte Carlo


How do you replace the ball joints on a 1998 Monte Carlo Z34??


The key and tumbler are on the side of the column. There is a rod that goes down the column to the ignition switch. It is accessed on top of the column and half way down.


The key and tumbler are on the side of the column. There is a rod that goes down the column to the ignition switch. It is accessed on top of the column and half way down.


If auto, it can be the neutras switch and if standard, it can be the clutch switch. Otherwise, take it to a garage as it can be the starter, solonoid, ignition switch or ????


Ask how to replace key switch 2002 Monte Carlo and when you get to remove dash with wire harness in middle stop and you will see three screws holding radio.


how do you change a heater core on a 2003 ss Monte Carlo


To replace fog light bulb of Monte Carlo you must remove the entire assembly. Replace the bulb that has been hindered and replace the assembly.


The dimmer switch, on your 2001 Chevrolet Monte Carlo, is located on the lower left hand portion of the dashboard. The dimmer switch is just below the heat vent.


More than likely it has a bad magnet in the ignition switch you need to replace the switch and then relearn the security system


The 1999 Chevy Monte Carlo does have an emergency fuel cutoff switch. The emergency fuel cutoff switch can be found in the fuse box.


Its pretty easy, as long as you have or have found a new switch. You just have to go to your local Chevy Dealer


I had that problem but played with the key abit and found I can pull the key out with it running. Bad ignition switch on mine.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.