Chevy Silverado
Jeep Wrangler
Door Panels and Handles

How do you replace an outer door handle on a 1992 Jeep Wrangler?

454647

Top Answer
User Avatar
Wiki User
2015-07-15 20:47:39
2015-07-15 20:47:39

If this helps at all on my 87 I took the door off and all the interior stuff (window knob etc) brought it in side. Once I got all the interior stuff of I took out the coter pin that connects the handles to the lock mechenisim (sp) and the hard part was they put these weadge thing to hold the outer handle on there are two of them they push up from bottom to top I used a long sloted screwdriver and hammer to tap it out then it just came out and then put the new on in and put back together in reverse order and should work. It is hard to test with the wedges out but it can be done. you. Tony tracksidetony@hotmail.com

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

go to the website autorepair.about.com and they have the step-by-step instructions. good luck!

User Avatar

I have a 91 Wrangler with full doors. First close the window on the door. Now remove the inside door vinyl panel. The handle is attached from the inside, as you can see. Removal and replacement is obvious from this point.

User Avatar

free diagram step by step at www.jeep4x4center.com

User Avatar

Yes, it was the exact same engine used in the wrangler in 1992, although if you didn't already have the 4.0 you will need an adapter to the transmission, or replace that too with an ax15.

User Avatar

A computer from a 1992 Wrangler with the same engine is what is compatible.

User Avatar

The correct factory tire size for a 1992 Jeep Wrangler is 215/75R15.

User Avatar

anyone has pictures out there for how to replace door handles for 92 Toyota corolla?

User Avatar

On the inside part of the handle there is a snap ring that holds the handle on, you need a special tool to remove the snap ring. Once removed, just pull off the handle.

User Avatar

A 1992 Jeep Wrangler with the 4-cylinder takes 4 quarts, and the 6-cylinder takes 6 quarts.

User Avatar

Six quarts of oil are needed to change the oil on a 1992 Jeep Wrangler.

User Avatar

Mt jeep wrangler has a dana 35 differential in it

User Avatar

Where is the fuel pump RELAY on a 1992 Jeep Wrangler

User Avatar

Jeep Wrangler wheel lug patterns years 1995-2006 are 5X4.5

User Avatar

Jeep Wrangler wheel lug patterns years 1987-2006 are 5X4.5

User Avatar

Jeep Wrangler wheel lug patterns years 1987-2006 are 5X4.5

User Avatar

No that will not work, 05 is a TJ and 92 is a YJ

User Avatar

This is a big job and you can cause your driveshaft to vibrate if you don't do it corretly. I suggest taking it to a garage.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.