Serpentine Belts
Nissan Sentra
Nissan Trucks and SUVs
Timing Belts and Chains

How do you replace and thread the belts on a 1986 Nissan 4WD pickup?


Top Answer
User Avatar
Wiki User
2015-07-15 20:01:24
2015-07-15 20:01:24

Is it the 86 or 86.5?

User Avatar

Related Questions

Yes 4 cylinder have chain and 6 have belts.

loosen the manual tensioners and the alt bracket.

tools...and ...everyone should have a manual for their vehicle, and the local library should have a professional shop manual available, to make copies of, in the Reference section...good luck:)

you need to drain all the freeon out of the system. take the belts off. and take the bolts on the compressor out. its best to get under the truck. and there is a lot of wiggling to get out.

Loosen the belts, unbolt the old alternator, bolt the new one on, tighten the belts back up.

BeltsYes, you must remove all of the belts to replace the alternator belt. The compressor belt first, then the power steering belt then the alternator belt.

You have three belts,ac,alt. and fan,and power steering.also timing belt.go to autozone,enter your vehicle info. and register and you can use their repair guide.

Check your belts for tightness or glazed edges. If the belts are loose, tighten them. If the edges are glazed, either break the glaze with a piece of scotch brite or replace the belts if they are worn.

Loosen the tension on the belts, unbolt the old one, bolt in the new one, and retighten the belts.

the pump is behind the fan. first drain the coolent. then you have to take off the belts and the fan. and remove the air intake. once all that's done you can get to the pump. i had the radiator out when i did it but its not necessary. it just makes for more working room

how do you replace the belts on a l-1011 fan jet

I believe that you have the VG30 engine, if this is true you have to remove all of the belts and to do that you must find all of the adjuster screws for the accessories that are attached to the appropiate belts and lossen the pivot bolts. once all other belts are removed you can begin replacing. my advice is to replace all the belts while you are there and save your self from the hassle of this again.

That is how it was designed and built.

how do you replace the drive belts on an 1974 mercedes 230

Two drive belts on the 93-97 altima 2.4.

how do you change belts on2.5 model sentra

disconnect battery and remove,drain radiator.remove top and bottom radiator hose,remove all 3 belts,remove fan shroud,remove fan blade,remove radiator,then remove water pump,when putting back together,replace thermostat.

need a diagram for changing belts in a 97 Nissan maxima

nthow to change the beltson the dodge neon

The cost of the belt itself will be at least $35.00. The price on having this replaced will depend on where the vehicle is taken for repair.

Replace the belt every 60,000 miles. This is an Interferance engine! If the belt breaks serious engine damage will occur.

Timing belts should be changed approximately every 80,000 miles.Check with Nissan about your specific vehicle. Several Nissan cars and trucks do not use belts, They use chains and almost never have to be replaced.

The life of serpentine and drive belts depends on the application, belt component quality and them being free of fluid contamination. New belts can often last 50-100,000 miles. However, it is always recommended to preemptively replace hoses at or before the manufacturer suggested mileage.

replace them - they are worn out

jack up the passenger side of the car. remove the splash guard in side the wheel well (all the black plastic inside fender)and remove the tire then u can acsess the belts. there are 3 sperate belts with non automatic idler pullys. loosen the idler pullys of the belts until u get to the compresser belt. replace then reinstall and tighten the belts with the idler pullys to repair manuel specs. a special tool will be required to get the correct tension of the belts

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.