The rear caliper pistons on this car cannot be squeezed back using a C-Clamp like the front assembly. The rear calipers need to be turned to be moved back. Use a large flat tool (I used a chisel) to turn the piston clockwise. Be careful that you don't damage the rubber around the piston.
how do you replace an alternator on a 1990 integra
Hou much should it cost to replace an alternator for a 1988 acura integra Ls?
yes but you will be disappointed
The brake lights are located in the trunk of a 1997 Acura Integra. To replace them open the trunk and find the plastic housing. Remove and replace the bulbs.
With a screwdriver.
91 acura integra has a b18 91 acura integra has a b18
From in the trunk
answer not for free.lol
very carefully lol
asfar as I know there is no integra tlAnswerTrue, but assuming the OP means an Acura Integra, jack up the car, remove the wheels, remove the calipers (two bolts on the back side), and carefully support them by wiring them to the spring (you don't want them hanging by the brake line), and then drill out the rotor screws (because the things always get rusted in there and are impossible to screw out). Then just pop the rotor off (you may need to whack the back side of the rotor with a hammer to break it free of the rust) and put the new one on. Do not replace the rotor screws - they're completely unnecessary. The lug nuts will hold the rotor to the hub just fine. You will need to open the calipers before you slide them on over the new rotor - depending on which brakes you have, you will either do this by turning a very large screw, or by squeezing a button in the center with a C clamp.Then just replace the calipers, and the wheels. Pump the brakes a few times with the engine on. Then roll slowly forward and hit the brakes. If the car does not stop, do not drive it. Jack it back up and figure out what you did wrong.
When replacing the rear turn signal on a 1999 Acura Integra open the trunk. Locate the rear turn signal housings and find the bulbs. Remove and replace the bulbs.
Yes it will fit
How to install a boost gauge in a acura integra?"
Yes it will fit.
When changing the corner lights on a 1992 Acura Integra first find the housings for the corner lights. Pull the old lights off and replace the bulbs.
Check your brakes and CV joints
When looking to buy parts for an Acura Integra then this may be possible by visiting the Acura Parts Online website that sells official parts for the Acura Integra.
No but to me it's just easier
same as for a 90'How_do_you_replace_the_alternator_on_a_1990_Acura_Integra
probably broke cluster,needs to be replace