Brake Pads and Rotors
Nissan Stanza

How do you replace brake pads on a 1992 Nissan Stanza?

333435

Top Answer
User Avatar
Wiki User
2014-09-18 00:22:43
2014-09-18 00:22:43

You will need to remove the tire and wheel from your 1992 Nissan Stanza. Remove the brake pad spring and caliper. The brake assembly will come off. Reverse the process to install the new brake pads.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

E.C.C.L. CRUISE CONTROL! In Nissan!

User Avatar

just like any other car, make sure that the e brake is off then grab a hammer and hit (hard) it a few times it should loosen up.

User Avatar

I believe that it is a chain, I believe that it is a chain,

User Avatar

Attached to engine block right under alternator

User Avatar

Follow the bottom hose of the radiator to the block. Where the hose enters is the location. Changing this has been answered.

User Avatar

http://www.ehow.com/how_7744525_change-injectors-1994-nissan-maxima.html

User Avatar

i just typed in 92 Nissan stanza in Google and about three down their is one that says body kits. they only sell one its 600.00 dollars but its pretty nice I would check eBay......parts and accessories category

User Avatar

i dont think there is a relay for the flasher, (if you are talking about the signla light) i think there is just a fuse for it

User Avatar

Passenger side engine compartment greenish reservoir with "POWER STEERING FLUID" printed on the lid

User Avatar

2 gallons, give or take. PLEASE USE DISTILLED WATER OR PRE MIX COOLANT. Your car will thank you!

User Avatar

Your alternator is defective. Could be the internal voltage regulator or one or more bad diodes. Replace as soon as you can to avoid getting stranded on the road.

User Avatar

my 92 Nissan has a belt make shure that its abelt and not a chain

User Avatar

It is important to know the cost of replace the parts of a car while owning it. The average cost to replace brake pads and rotors to a 1992 Buick LeSabre as a kit would be about $300.

User Avatar

for the 3rd brake light removal, push the lower right side of the plastic housing to the left and easily push up. it will come right out, before pulling completely out disconnect the quick connect by sqeezing tab...

User Avatar

loosen adjuster bolts and take off belt......

User Avatar

Changing brakes is a pretty simple task. Lift the car, remove the tire, brake shoe/caliper and remove the old pad. Put in the new pad, replace the brake shoe/caliper, put the tire back on and lower the car.

User Avatar

It is located in the center console. behind the cigarette ash tray. It is the one that has a large blue colored connector (many wires are connected to it).

User Avatar

the fuel filter is located on firewall on drivers side......has 2 fuel lines going to it one on bottom and one out of the top

User Avatar

1992 Lexus es300 wear the thermostat is located


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.