Lift the car, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Next put in the new brake pads, put the brake shoe/caliper in its place, put the tire back on the car and lower the car.
vacuum leak at the master cylinder or vacuum line to the master cylinder
Lift the car on a jack, remove the tire, remove the brake shoe/caliper and remove the old brake pad. Properly dispose of the old pad, put in the new brake pad, replace the brake shoe/caliper, put the tire back on and lower the car.
with wrenches.
Look on bottom or rear of radiator
yes they will. as long as both jeeps have stock axles.
The 1993 Jeep grand Cherokee brake light switch simply plugs in and out. The brake light switch is located beneath the dashboard on the drivers side of the engine compartment.
Fuse panel. under the hood by washer reservoir
driver front on inside of fender next to airbox
The Jeep Grand Cherokee didn't exist until 1993.
I had same proble with my car just today. Mechanic asked me to replace brake boosters and also might be need to replace perportional valve. These parts are only available from a dealer and because of weekened i was`t told that how much does it going to cost me.
Replace the caliper and bleed the brake system.
It goes into the brake fluid resevoir, a tank located in the engine compartment. Specific location will vary depending on the engine you have.