if it is an LED unit you cant you have to change the assembly as a unit
Remove the wiring harness from the high mount brake light. Remove the retaining screws. Reverse the process to install the new high mount brake light.
replace u joints or motor mount or transmission mount
go to your dad for help he would like that
To replace the dome light gently squeeze the lens to release the clips and remove. Next release the bulb from its mount. Install the new bulb and replace the lens.
IF you torque the motor up the motor will rock badly, also if you hit the gas hard it will clunk. As a Gm tech. i have never seen a motor mount go on a suburban or any k truck.
You can replace your 1995 Chevy Corsica motor mount by loosening the motor mount retaining bolt. Jack the engine up approximately 3 inches. Remove the motor mount retaining bolt and the motor mount bushing. Put the new motor mount bushing in and reverse the process.
It all depends on what type. Console, roof mount. If its a roof mount try to mount it where the overhead courtesy light is and screw into the beam. Make sure the screws are not to long or you will go through the roof. Make sure you fuse it when getting power from the fuse box or Ignition harness.
Whats the easiest way to get broken cab mount bolts out on a 1994 chevy 1500 extended cab
you have to remove the whole control panel assembly. pull off dash front panel, unscrew the panel, unplug the wires and remove th cable. the blower switch mount from the back of the panel
I had no problem replacing the blower motor in my '95 Suburban without taking the glove box or computer mount out. I removed the sound insulating cover from the motor and five screws that hold the motor in , unplugged the wires and then reverse the procedure to install. Done in about 20 minutes. You have to pull the glove box and the computer mount to access the motor. If you bur a Haynes repair manual it gives great detail
It is as simple as removong 2 bolts and replacing the mount. Goodluck, JOe
if it is the same as the 2004 then you would be looking for a 14mm or a 9/16 size