The wheel bearings are part of a hub on the 1999 Grand Am. A new hub is a little over $100 dollars. To get it off, you must first pull off the wheel, the brake caliper and bracket that holds the brake pads. There are 3 bolts on the back side of the strut tower that need to be removed. You will need a 36mm impact socket to remove the axle nut. An electric or air impact wrench will ease the removal of the nut. You will strain yourself if you just try to use a ratchet. A slide hammer will need to be used to separate the hub from the axle. Make sure that you disconnet the wire plug going to the traction control that is connected to the hub. Be careful when using the slide hammer so as not to pinch the wires from the traction control when the hub is completely loosened from the axle.
You can't replace just the wheel bearings. You have to replace the whole hub assembly. Costs about 200 bucks per wheel at a repair shop. I have had both of mine replaced.
yes
change front coil spring on 2000 Pontiac grand am
Grand Ams eat wheel bearings, if one is bad you might as well replace both of them as the other will go out in a month or so, I had a 94 and replaced 6 wheel bearings in that car in 113,000 miles.
The front wheel bearings, of a Pontiac vibe, can be replaced by first removing the front wheel. Next, remove the axle end cap. Remove the bearing and reverse the process to install the new bearing.
pictures of how to change front signal bulbs on a 2004 grand prix pontiac
Not unless you want to - certainly not required though
The front wheels bearings are sealed in an assembly. You cannot replace the bearings, just the entire assembly. I priced out the units about 5 years ago and I was quoted anywhere from $150 to $225 each. I asked the parts suppliers if replacing them is a DIY job and most advised against trying it myself.
The 1996 Pontiac Grand Am is a front wheel drive application. This vehicle has sealed (non-serviceable) and bolt-in wheel/hub bearing units. Removing and replacing them involves removing the wheels/tires, brake rotors and then unbolting the wheel/hub bearings. The General Motors OE front hubs are AC Delco #2025K.
Yes..you should be able to. You'll have to take off the starter, remove the front engine mount to be able to lift the engine slightly then remove the oil pan.
underneith the front bumber twist counter clockwise replace bulb
How do you replace the front wheel bearings on a nissan frontier 4x4 1999