remove valve covers and high pressure oil rails(T-30 torx) remove inj with t-40 or t-45 torx lube o-rings and torque injectors 24ftlbs t-40 or 26ftlbs t-45 if you are not carfull a cut o-ring or inproper torque will cause o-rings to burn from combustion gases and dump fuel into cylinder and hydrolock engine which could cause engine dammage. This does require some special tools that most people do not normally have and a few tricks on how to get things loose along with about 3hours pluse per side for normal person. Pain in A##.
To replace injectors on a 1999 Ranger 3.0, first eliminate the fuel pressure. Then remove the rails as well as the fuel lines. Finally, remove the o-rings and replace injectors with new.?æ
Sterling 10.25
f250 superduty is a 3/4 ton pickup
To the right of the gas pedal, behind the center consol.
The heater core on a 1999 Ford F250 Superduty is replaced by removing the heater hoses, disconnecting the wiring harness, and removing the retaining bolts. The cover can then be removed, the heater core unbolted, and removed from its housing.
not one
5x7 or 6x8 fit.
no
Mercon V if it has an A/T.
fuse layout for under dash fuse box f250 super duty
Check for a loose ground cable
You don't have a cabin Air Filter!
right hand side front of engine