Want this question answered?
two bolts on the top of the plastic housing - lift the plastic headlight out and unscrew the headlight from the bottom of the light- replace the bulb and be sure to get the plastic pins in the right spot before you bolt the headlight back in place.
Gain access to the rear of the headlight housing. Remove the weatherproof rubber protective boot and remove the headlight bulb socket. Replace bulb and re-install in reverse order.
Open your hood and remove the 2 push pins that connect the engine compartment plastic separator. There are also 2 bolts to remove and then you can pull the headlight from the frame. Replace the bulb and put the headlight back.
If you are talking about the bulb itself all you have to do is look at the back of your headlight encasement and there will be wires for the bulb going into the encasement. There is a plastic lock on the back of the headlight. Just turn it, and then all you have to do is pull out your headlight, replace it, and pop it back in just the way you took it out. Make sure to twist the plastic piece until it locks (doesn't take much).
There is 2 large plastic screws that hold the headlight assembly`s in. Simply unscrew them and lift the headlight assemblies out then unhook take the bulbs out.
what you do is you open the hood and right above the headlight is a black plastic cover held on by little plastic clips. take that off and you'll see two bid bolts connected to the frame of the headlight. take them off, jiggle the headlight alittle, and it should come right out
When you open the hood look above the headlight for two round plastic caps. Pull these upwards, it releases the light assembly.
To replace the headlight bulb in an S type Jaguar, you will first have to remove the plastic cover across the top of the assembly. After moving the turn signal bulb assembly out of the way, you then remove the second plastic cover from behind the assembly and replace the bulb from there.
Pull out on the plastic plug attached to the bulb the whole bulb will come out, pull apart the plastic adapter to the wire and the wire connector, then attach new and replace.
how to replace the headlight
there are actually no screws. pop the hood and look for the plastic tabs above the headlight...one on each side of the headlight. pull them straight up and voila'.
There is lots of space to replace the headlight just unscrew the bolts i think its 2 of them and there is a plastic clip that usually holds them in.