0
How do you replace just the receptacle part for a seat belt on VW Passat you can't get a wrench on the bolt?
Wiki User
∙ 17y ago
you need a torx bit
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Mileage to replace timing belt for a Volkswagen Passat 1.8t?
80,000 miles
How much does it cost to replace a timing belt on a 2002 VW passat vr6 glx?
$0 It does a VR6 has no timing belt. Rick
MY volks wagon passat 2000 has 107239 mile does the timing belt need to be replace?
Yes and if the belt breaks it will damage your engine.
When to replace timing belt on 2001 vw passat 2.8L?
Should be replaced every 105,000 miles.
How do you replace belts on 1994 Toyota corolla?
There is only one belt, the serpentine belt. You use a wrench to loosen the spring loaded tensioner and remove and replace, there is no timing belt it has a chain.
How do you replace Serpentine belt 95 pathfinder?
Take a 14 mm wrench and put on the center bold of the tensioner. Then pull back releasing pressure on the belt. Remove and replace. Take a 14 mm wrench and put on the center bold of the tensioner. Then pull back releasing pressure on the belt. Remove and replace.
What tools are needed to replace the drive belt on a 2000 ford focus?
Only a wrench to rotate the belt tensioner to releive the belt tension. You have to get at it via the passenger-side front wheel well. The longer the length of the wrench, the better.
When should you replace the timing belt on a 2002 passat?
VX recommends replacing the timing belt between 80k and 100K VX recommends replacing the timing belt between 80k and 100K
How do you replace a serpentine belt on a 1996 vw passat glx?
This is the timing belt, I think. Takes a lot of expertise. Get the shop manual. If you screw it up, you can damage the engine.
How do you replace a BMW E36 alternator belt?
Release the tension using a wrench etc from the idler pulley.
How do you replace the serpentine belt on a 1995 Chevy Beretta?
put a socket wrench,on belt tensioner,there should be a small square hole there,that fits a socket wrench,lift upwards,careful not to slip wrench,then belt should lift up and come off,slide on new belt,lift upwards again,then let down slowly once belt is on.your done.easy.
My timing belt broke on your 1999 vw passat 1.8t motor do i need to replace a valve?
if the engine was turning when belt broke most likely tagged one valve, replace belt and compression test ot borescope to view inside cylinders for damage.
