I am not a Ford man but motor mounts for a 351W engine may be what you want.
The 1997 Ford Taurus has for motor mounts and to transmission mounts. Worn motor mounts and transmission mounts will allow the engine and transmission to have movement.
how do you replace the freeze plugs between the transmision and motor on a 1997 f150 5.4
Carefully place a jack with a block of wood under the motor, loosen mounts from motor, jack motor up just enough to remove old mounts, replace mounts, lower motor onto new mounts, tighten motor to mounts. Make sure there aren't any hoses, wires, lines, etc. that may tear while lifting the motor.
directions to change the motor mounts?
Can you put a 350 gm motor in 97 ford f150
Remove motor mounts and raise motor approximately 4 inches.
You will need to unbolt the motor and transmission from their mounts. jack up the motor, drain and remove the lower oil pan. That should give you access to the pump. If your going to do it you might want to change your main barrings at the same time.
Ford never made a 350 motor
How do you remove and replace the battery on a 2001 Ford F150?
Need to know what model year and what engine in order to answer this. The F150 name has been in use since 1975, and the mounts for a 1975 with a straight six are going to be different from a 2014 with a V8.
The FE 352 cid ford motor has the same external dimension as all FE motors. Pre-1965 blocks (332, 361, 390, 427) have the same motor mounts. After 1965 engines have a different mounting holes, some machining/drilling would be needed, or custom motor mounts.
The 300 I6 as well as the 351 V8 will bolt up to the transmission with no issues. However, the 300I6 will require the motor mounts to be relocated.
L4, there are 3 mounts, engine and transmission.
it should be next to the blower motor
how to replace an oil pan that goes to a ford f150 1993? how much does the pan cost,and can you show a picture of it?
How do you replace the tail gate latch on a Ford f150
at is the cost to replace a blower motor on a ford focus
Depending on the motor is it a 108 or a 205