answersLogoWhite

Top Answer
User Avatar
Wiki User
Answered 2014-08-26 19:39:28

The process to change the pressure sensor is the same for any engine in the 2005 Silverado, but the location may change between engine types. The sensor should be close to the oil filter. Remove the sensor wire, then screw the sensor out. Screw a new sensor in, then reconnect the wire.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Related Questions


how to replace a fuel line presure regulator on a 2004 4.8 chevy silverado


how do you change the knock sensor in a 2003 Chevy silverado 5.3


replace fuel filter 2008 Chevy silverado


In 2000 they weren't using one yet There is a variable fuel pressure regulator.



how do i reinsert the fuel injectors on my 4.3 Chevy silverado


The 1995 Chevy Silverado coolant sensor is located on the front of the engine. The coolant sensor will be a few inches above the thermostat housing.


Working on the SRS can be very hazardous. For this reason I suggest you have this repaired by a professional.


were is pressure regulatore on Chevrolet silverado 1500 5.7


On the 1999 Chevy Silverado Z71 4WD, the speed sensor is part of a module. It is located next to the transmission housing.


The speed sensor on a Chevy Silverado is located on the tailshaft of the transmission. To remove it, unplug the wire hardness, unscrew the bolt holding it in place, and pull it out.


you have to pull off the intake they are under there. you have two you might as well replace both


No. Check the battery first. Then test for spark, fuel pressure, and test your coils.


Yes.. But it would be cheaper to just buy the whole regulator and replace it.


The Manifold ?æAbsolute Pressure sensor is located on top of the manifold. It is just forward of the intake manifold and held in place with a bracket assembly.


The sensor you are looking for is an integral part of the door latch.


The 94 model does not have a MASS AIR FLOW SENSOR.


The sensor you are looking for is an integral part of the door latch.


I have an 05 silverado 1500 and the temp sensor is on the driver side head in front of the exhast manifold.


Its under intake but it is prob. the oxygen sincere had the same code come up it was the ox.sen.



need to find out how to replace a power brake booster in a 2002 Chevy silverado 2500 HD


on a 2002 Chevy silverado with a 4.6 liter v6 where is the coolant sensor for low coolant. I have a light on and check the overflow and their is coolant but don't know if their is another one or not.


That year did not use a crankshaft sensor. It used an ignition module.


The intake temperature sensor is located on the side of the air filter case on a 2003 Chevy Silverado 4.3 1500. It is on the top of the engine.



Copyright ยฉ 2021 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.