Ford Tempo
Chevy Tracker
Timing Belts and Chains

How do you replace or loosen the main drive belt on a 1991 Ford Tempo?

456

Top Answer
User Avatar
Wiki User
Answered
2008-08-02 16:22:20
2008-08-02 16:22:20

Look for the tensioner...it will look like another of the smaller pulleys. There should be a square hole in it that a 1/2 ratchet should fit into. Using pressure you should be able to release tension on the belt to remove it and then apply tension to install the new one

good luck..hope this helps, as I'm going by memory

Hippy

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Yeah my 1991 Ford Tempo does the same thing it starts and idles no problem but if i stop at a gas station and leave it running and come back out to the car i put it in reverse or drive it dies every once in a while

LET ENGINE COOL LOOSEN TOP @ BOTTOM BOLTS SLIDE INWARD UNPLUG WIRES LOOSEN BELT REMOVE

The cast of Galicia no tempo - 1991 includes: Eva Veiga as Herself - Hostess

The cast of Tempo di riposo - 1991 includes: Carlo Colnaghi as himself

Need a diagram to set the timing Mitsubishi 1991 pu

To replace the clutch disc in a 1991 Acura Legend you must first remove the engine from the vehicle. Loosen the pressure plate by adjusting the bolts and remove. Put the new one where the old one was and tighten the bolts.

what size socket for front axle nut 1991 ford tempo

To loosen a tension pulley on a 1991 Chrysler New Yorker, turn the nut in the center of the pulley. This will allow the pulley to slide in the cut-out groove so that the belt will loosen.

To change the brake rotors on a 1991 Honda Civic raise the vehicle. Remove the wheels and brake caliper bracket. Remove the brake pads. Loosen the rotor mounting screws and replace the rotors.

fuel pump is in the gas tank.!!

According to my Chilton's Auto Repair Manual : For the 1991 Ford Tempo , 2.3 litre four cylinder engine : ( 5.0 US. quarts with engine oil filter change )

I want to say no, because the tempo has a bigger transaxle than the escort.

Yes, there is a brake line diagram for the 1991 Ford Tempo. It is found in the cars repair or maintenance manual.

The 1991 Ford Tempo radiator plug is on the bottom of the radiator. The plug can be removed with a half inch ratchet.

In the rear mounted under the vehicle.

its in your fule tank you have to drop your tank and remove your sending unit drive safe

Replacing the head gasket on any vehicle is a long and complicated process, however if you wish to see basic step-by-step instructions go to the related question on the right side of the page "How do you replace a head gasket?"

I'm pretty sure that on that vehicle the slave cylinder is located inside the transmssion which means the transmission must be removed to replace it

how to replace a water pump on a 1991 acura legend

how do you replace a ignitionswitch tumbler 1991 buick skylark

The factory spec for tires for a '93 Ford Tempo is P185/70R14. As far as I know it would be the same for all years.

loosen up the bracket that holds the tension on the belts then tigten up the adjustement bolts that pull the bracket then re tighten the bolts.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.