Want this question answered?
get a new one
Check the underneath of lawn mower for grass built up.
Use pliers to pull cord or replace latch.
you would take off the cover and expose the recoil spring/shaft then detach the string and put the new one on
first u need to remove the screws holdiny the pull cord housing then u remove it and pull the old cord out and hold it then remove the end of cord that has the knot to keep it in place wen u install new one do reverse but dont let the cord wheel go back
On most of them you hold the top part with one hand and turn the bummer/spool clockwise (looking from the top)and pull it straight down/outward
take your cover off of the pull cord, there should be a slot in the wheel that turns your crank, take your cord and tie a knot at the end of it a slip it in the slot wind the cord around the wheel bolt cover back on go have some fun....
if your not a DIY person then take it to a shop, or remove pull cord cover, and pull out old cord, turn the pully" that the cord was on to wind up the spring, thread new cord into hole in pully tie a knot in end let it rewind cord back in, Get a armor cord they will never break they are tested to 1 million pulls,break 1 get 10 free i just changed everything i have a put the armor cord in it. armorcord.com
To replace high mounted stoplight - 1. Remove hump on high mounted stoplight by pulling hump towards you then pull up. 2. Pull electrical cord out and pull bulb out. 3. Replace bulb 4. Replace hump by pushing it away from you then press down.
remove head pull shaft out
Simply, unclip the pull chain, unwrap the cord and add an new one.these can be found here: lancashire Rose Blinds
You can start it by using the pull cord, just be sure the key is in the ON position.