1500 or 2500???
1500 or 2500?? 6 lug or 8 ?
how do you remove front rotors from a chev 2004 silveraldo crewcab not 4wd
how do i replace front wheel bearinbs on 2000 ford ranger 4wd
need to replace alternator on a ford expediting 2003
take it to the dealer
are 2wd and 4wd front brake rotors interchangeable on 1997 ranger 4L V6 XLT
After you remove the brake pads and break assembly, tap on the brake rotors with a hammer or mallet. The brake rotors will come loose. Slide the brake rotors off.
Get yourself a good manual for Ford truck repair and follow the directions. Its that simple. I just replaced the front rotors and pads on my F-150 Super cab with 4WD in about 2 hours. I had only done this once before and on another car. Cost about $150 for parts. Would do it again in a heart beat. Get yourself a good manual for Ford truck repair and follow the directions. Its that simple. I just replaced the front rotors and pads on my F-150 Super cab with 4WD in about 2 hours. I had only done this once before and on another car. Cost about $150 for parts. Would do it again in a heart beat.
You can replace the speedometer cable, on your 1988 Ford Ranger, by loosening the cable nut on each end of the cable. The cable will come off and can then be replaced.
Good idea to do so
Most four-wheel-drive vehicles are controlled by the transfer case. The transfer case has many years in it. A bad year in the transfer case will cause the vehicle not to engage.
well,, you can start by turning the switch on your dash that says '4wd'
A 1987 4-speed ford ranger with over drive is a 4wd and not 2wd.
remove brake parts after removing tire should slide right off
Get a shop manual for about $18 and it has pictures and everything.
Anywhere from $500-$1500 depending on where you go. Not an easy job takes about 4-8 hours
how do you replace a wheel bearing assembly on the left side of a 2007 chevy tahoe with 4wd and abs brakes
When changing the brake rotors on a 1990 Toyota 4runner the vehicle must be safely raised and propped up. The calipers must be loosen and rotors will be able to be removed. The process must be repeated for all four wheels.
Ford EXPEDITION 2WDFord EXPLORER 2WDFord EXPLORER 4WDLotus ELISE/EXIGE
It is for the 4WD control knob. In models without 4WD it is just an extra place to put something.
This will depend on what vehicle, what year, and is it 4wd? Try asking a more specific question.