Spark Plugs and Wires
Timing and Firing Orders
Honda Civic EX

How do you replace spark plug wires on 1999 Camry?

363738

Top Answer
User Avatar
Wiki User
Answered
2008-02-29 06:11:38
2008-02-29 06:11:38

Very simple to do. Purchase 4 new platinum spark plugs for the vehicle. You will need a spark plug socket (it has rubber on it to grip the spark plug you are taking out) and an extension of at least 8 inches. When you open the hood you will see the 4 spark plug leads on top of the engine. Unplug the leads ....put the spark plug socket down each hole and unscrew the spark plugs. The new spark plugs will likely be already gapped to the .043 inches needed. Screw the sparks plug in (I made sure I did not put the spark plug socket on the spark plug too tightly or you could leave the spark plug in the socket hole. A 15 minute job at the most

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


You should have C.O.P. ( coil on plug) there are no wires.

you have to replace all of your spark plug wires. there is a coil built into the top of each boot that goes over each spark plug. that's why the wires are so costly.

where is the thermostat located in a 1999 Toyota Camry located and how do you replace it.

If you open the hood and can see only 3 spark plug wires: you have 6 cylinder engine. Otherwise you have 4 cylinder engine (you can see only 4 spark plug wires).

check spark plugs, and spark wires, they may be cracked or dirty you may also need to replace your battery check spark plugs, and spark wires, they may be cracked or dirty you may also need to replace your battery

? wiper switch toyota camry 1999 replace

I suspect you have V6. If it is the case, you will have to remove intake manifold. There is no other way to replace it.

Mark and remove plug wires. Remove spark plugs and install new plugs. Reattach plug wire to correct plug.

cost to replace the radiator in my 1995 4 cyl. Camry today will be $220.

they are attached to the ends of the spark plug wires

How do I replace the spark plugs in a 1999 Cadillac Catera?

Changing the spark plug wires in your 1999 Mercedes-Benz is quite simple. The spark plug wires simply lift off. The new spark plug wires can be pushed onto the spark plug. It is best to change one wire at a time.

Sorry I do not replace sparkplugs.Take your 1999 BMW to a garage, they will do it for you.

The torque for spark plugs is 18 N*m or 13 ft*lbf.

remove the ignition coils on the intake and they are underneath it. your vehicle has distributorless ignition, therfore there aren't any spark plug wires, instead it has individual ignition coils with the spark plugs directly underneath them.

I'm trying to find the answer for that on a 1997 Toyota Camry.

In the engine ... usually on both sides or inline on the top.

check the gappings of your spark plugs, it must be uniform.

The 1999 model, 90 hp Mercury outboard requires an NGK BUHW-2 spark plug, standard plug wires are acceptable.

You need to replace your spark plug wires!! You can check this by spraying water on your spark plug wires when it is dark. Then start your engine and you should see the wires arc and your engine will be running rough just as it does when it rains or after a rain. Good Luck

there is no cap it has a coil for each plug wire on the motor remove one wire at a time and replace it

http://www.richinese.org/mm/upload1/camry_radio.pdf


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.