Auto Parts and Repairs
Geo Tracker
DIY Projects

How do you replace speedometer cable on 1996 Geo Tracker 2 door 4wheel drive?

012

Top Answer
User Avatar
Wiki User
Answered
2014-08-27 22:43:52
2014-08-27 22:43:52

The 1996 Geo tracker speedometer cable is held in place by a retaining nut at each end of the cable. Loosen the retaining nuts. Remove the speedometer cable guide retainers. Reverse the process to install the new speedometer cable.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Speedometer cable replace 1989 toyota

How to replace a speedometer cable in a crown vic

The speedometer is electronic on a 1999 Ram, and does not have a cable.

There is no speedometer cable on that vehicle. The speedometer is driven electronically.

A 2004 Buick does not have a speedometer cable. The speedometer signal comes from electronic sensors.

It's usually the cable or the speedometer head in the dash that have problems Is it possible to lubricate the where the cable and the speedometer head cluster meet? If so, how do you get into the head or cluster?

There is not an odometer cable. The odometer is driven by the speedometer. If the odometer is not working then you will have to replace the speedometer head.

I pretty sure it doesn't have a speedometer cable, it is electronic.

You can replace the speedometer cable, on your 1988 Ford Ranger, by loosening the cable nut on each end of the cable. The cable will come off and can then be replaced.

How do you replace a speedometer cable on a 1984 Yamaha virago xv1000

The 1991 Geo speedometer cable is held in place with a swivel nut on each end of the cable. Turn the swivel nut to the left to remove the speedometer cable. Reverse the process to install the new speedometer cable.

how to replace the SPEEDOMETER cable on a 2003 kawasaki voyager

There are several things you can do to repair your speedometer. You can replace the speedometer cable. You can replace the speed sensor in the transmission.

There is no speedo cable on a Sunfire.

Your 1988 Nissan 300 speedometer cable is held in place with swivel nuts on each end of the speedometer cable. Turn the swivel nuts to the left. The speedometer cable will come off. Reverse the process to install your new speedometer cable.

The 95 Camry does not have a mechanical speedometer cable. There is a speed sensor located on the top of the transmission that is connected by wire to the speedometer.

A 1993 Jeep Grand Cherokee does not have a speedometer cable. The speedometer signal comes from a sensor on the transmission or transfer case.

remove cluster and replace cable. Reverse removal procedure for installation.

No, you just have to have a small hand to get in back of the speedometer.

odometer cable and speedometer cable are the same thing, unscrew cable from speedometer head under the dash and unhook it from the tranny and pull the cable out and replace with a new one.

You didn't mention what year the S10 is but, yours probably doesn't have a cable driven speedometer. It is electronic.

there is no cable only speed sensor on trans

1996 ranger does not have speedo cable it is electronic

Remove the dashboard cover. Remove the retaining ring, from the speedometer. Remove the speedometer cable from the back of the speedometer. Reverse the process to install the new speedometer.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.