Shocks and Struts
Oldsmobile Cutlass Supreme
Dodge Dynasty

How do you replace struts on a 1991 Dodge Dynasty?

565758

Top Answer
User Avatar
Wiki User
Answered
2006-09-18 00:01:14
2006-09-18 00:01:14

there are three bolts on the top of the strut tower. There are two bolts going through the bottom. There are also the brake line brackets. Just remove all of those, and pull off the strut. if you have the cartridge only, you will nees a spring compressor to swap that. To install it, just put everything back... TIGHT. You will need an alignment when finished, the camber will be screwed.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The PCV valve on a 1991 Dodge Dynasty 3.0 engine is on the passenger side of the vehicle. It is on the crankcase.

a diagram for a 1991 dodge dynasty w a 6 cylinder 3point 3 liter engine

what is a controller in 2.5 motor in a dodge

I believe about $800 at least with struts only and plus $400 if you want to replace springs too.

The 1991 Dodge Dynasty starter relay switch can be found in the fuse box. The starter relay switch will be in the third column, third from the top.

What you need to do is open the trunk. Then you need to remove the liner in the back of the trunk closest to you then you can see the wires the twist out.

The fuel pump is located in the fuel tank, meaning you'll have to drop the tank in order to replace the pump.

A 1991 dodge dynasty speedometer bouncing could be a sticking speedometer cable, or a bad drive gear. Check the cable first, and lubricate it to see if the problem stops.

The engine computer is behind the battery.

Your fuel pump will be inside the gas tank.

It threads into the exhaust manifold on the back of the engine.

AnswerIt is in your fuel tank. The tank has to be dropped to replace it. How to replace the fuel filter in the 1991 Dodge Spirit?Oh by!!!!, good luck

Dodge doesn't use fuel switches. The fuel system is computer controlled with relays.

Bring to a shop that has an ABS Scanner

Depends who does it. It could take upto 3 hours of labour and struts start around ยฃ65 for gas replacements. Oil filled struts are better but dearer.

5w 30 or 10w 30 will work just fine

The voltage regulator is located in the Single Board Engine Controller (SBEC or ECM). If you have to replace it, you have to replace the computer. The computer has the voltage regulator in it. The alternator gets feedback from the computer to produce more of less voltage.

all idle speeds arfe controlled by the computer and are not adjustable.

Dodge Dynastys dont have Fan Belts... Their fans run on an electric motor.

best results are to replace the air struts with conventional macferson struts.use Taurus struts of the same year,front struts are straightforward,however the rears my need one hole drilled to access the difference in the bolt pattern of the upper strut mount.

how do i change a water pump in a 1991 dodge shadow with a 2.2 liter does it require an internal water pump


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.