How do you replace the CV joints on a 1993XE?"
How do you adjust timing chain on a 1990 sentra?
AnswerWhere can i find a diagram to locate where the starter is on a 1993 Nissan Sentra automatic
Have to remove the door, then remove pins and bushings
I have a 1993 Nissan Sentra. It jerks in first gear. While changing to 2 - 4, it runs very smoothly.
I need a diagram to connect at clucth cable from a nissan sentra 1993 4 cilinder stitf shift,
To do the job correctly, get a manual on your car from AUTOBOOKSONLINE.COM which will help on the next repair.
yes the trans is the same in all 91-94 for the 1.6L motor
The brake light switch is located above the brake pedal on a 1993 Nissan Sentra. To reach the switch the driver's door needs to be opened.
More than likely you have a valve cover leak. You probably need to replace the gasket(s).
none of the parts well interchange at all.. except for nuts and bolts.
Go to a car dealer for that car you have Nissan and ask them.
Timing CHAIN ( 1.6 and 2.0 liter )
where is the location of a water pump on a 1993 Nissan maxium located
i have the same question. pepboys wansy $350
buy a new one and wire it up with a soldering iron
I replaced the motor in my 1993 G20 with a motor from a Nissan Sentra from Japan.
The 1993 Nissan neutral safety switch can be found on the left-hand side of the transmission. The neutral safety switch will be near the front of the transmission.
On the 1993 Sentra the speedometer sensor is located on the top of the transmission on the drivers side near the firewall. I have the same problem and would like to replace the sensor but cannot seem to get it out. Do you know how to remove? email@example.com Art Plymouth, MA
have a mechanic sheck for a blown head gasket or a craked head
It is the starters breaks after it finishes starting the car. It is normal and it is ok.
Mounted on top and inside the fuel tank.
There is no fuel warning dash light in my 1993 Nissan Sentra.
If speedometer itself is working then gears inside the assembly are damaged.
Vacuum leak, bad spark plugs, plug wires, or all three. Replace all vacuum hoses, plugs and plug wires. Replace the hoses one at a time so as to not get confused.
Check the vacuum hose that feeds into the cruise module in the engine.