answersLogoWhite
EGR Systems
Nissan Frontier
Nissan Maxima
Toyota Camry

How do you replace the EGR valve on a 1995 Camry?

8910

Top Answer
User Avatar
Wiki User
2006-06-04 16:47:26
2006-06-04 16:47:26

I have replaced the old with a new egr valve, but my car is like hestitating for gas or something. The idle hand goes up or down or even when the car is in park or drive its tends to want to pull on its own. So I would like to know what are my complications with this vehicle.

1

Related Questions

User Avatar

Its under the EGR on the block ya. follow a hose from egr to vsv from underside of car

User Avatar

I just replaced the EGR on my 1997 Toyota Camry 4cl and it was about $300, the downside is that I purchased a part with only a 6mo warranty and at 7 mo it went out again...

User Avatar

The 1995 Hyundai Elantra EGR valve is located on the firewall in the engine compartment. The EGR valve will be on the passenger side of the firewall.

User Avatar

how much does it cost to replace to egr valve on the 2002 mazda protege

User Avatar

You need to replace the EGR valve. Make sure to replace the plugs too after that.

User Avatar

The egr valve is located on the top rear of the engine. It bolts on and is easily removed.

User Avatar

Where is the EGR valve located on a 1995 dodge 1500 5.2 liter

User Avatar

The EGR valve is bolted to the rear cylinder head at the transaxle end

User Avatar

The egr valve is located on top of the engine. It is close to the firewall, mounted close to the center from side to side.

User Avatar

Usually you replace the egr valve.

User Avatar

How do you replace the EGR Valve on a 2001 Ford Escape?

User Avatar

location of egr valve on 04 grand am v6

User Avatar

No but if there is still an EGR valve problem then its the EGR Valve switch located at the back of the motor. I replaced my EGR valve 2 times before I figured out it was the electrical switch, which had burnt up, for the egr valve. I havent had a problem with the EGR since then..

User Avatar

You unscrew the bolts.

User Avatar

http://thecommi.angelfire.com/index.html I have included a picture of the EGR valve on my website. scroll down and click on EGR valve. the valve is easy to replace. remove the wireing connector from the top, remove the two 10mm mounting bolts from its base. pull strait up and off. should take under 10 min to replace. http://thecommi.angelfire.com/index.html I have included a picture of the EGR valve on my website. scroll down and click on EGR valve. the valve is easy to replace. remove the wireing connector from the top, remove the two 10mm mounting bolts from its base. pull strait up and off. should take under 10 min to replace.

User Avatar

can you clean a egr valve on a 1995 pontiac firebird with a 3.,4 litre motor

User Avatar

I haven't looked at a 1996, but it probably threads into the valve cover.

User Avatar

The EGR valve is bolted to the rear cylinder head at the transaxle end

User Avatar

It depends if it is a 4.3 or the 2.2 engine but, in general the EGR valve is located on the intake manifold.

User Avatar

Replace the EGR valve. It routs 1200 degree exhaust into the 1800 degree combustion chanbers to decrease preignition and reduce nox.

User Avatar

Remove the wiring harness from your 2000 Dodge Stratus EGR valve. Remove the EGR valve retaining screws. Reverse the process to install the new EGR valve.

User Avatar

That's your EGR valve flow is insufficient. Replace the EGR valve.

User Avatar

good luck with that most 99's didnt have an egr in the camry if its a v-6


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.