You will have to go between front bumper and under the wheel plastic reflector, you will not have to remove any of them, if you lay down on the ground you can reach bulb socket and turn counterclockwise it will lose them up replace bulb with proper one and install it back turning clockwise
the bumper will have to be removed.
drop the bumper and take the headlight housing out
you have to remove the screws from the top of your bumper and remove the screws from the front of the wheel well bumper should slide forward then remove two bolts on top of headlight then remove bolt under headlight then housing should come right out
First, you'll need to remove the front bumper. To do this, take off the bolts underneath the front part of the bumper. Remove the bumper turn signals to access the two bolts per side that hold the bumper on the car. Support the bumper by putting something underneath it. Then get a stubby Phillips screwdriver and remove the two screws per side at the end of the bumper (in the wheel well). Bumper should come off. Remove the headlight assembly by diconnecting the headlight sockets, remove the 10mm bolts above each headlight assembly. Remove the 10mm bolts below the headlight assembly. Done.
To replace the headlight assembly on on 03 Jetta, the grill and front bumper have to be removed before you can get to the screws below the lamp.
yes
You have to take the bumper out. Watch for hidden clips behind the bumper and work slowly. After removing the bumper taking headlight assembly out is as easy as removing couple of screws. Before you do that make sure you check both the bulbs and fuses for the headlights. Each light has it's own fuse
You have to take the bumper out. Watch for hidden clips behind the bumper and work slowly. After removing the bumper taking headlight assembly out is as easy as removing couple of screws. Before you do that make sure you check both the bulbs and fuses for the headlights. Each light has it's own fuse
its located behind the front bumper by the passenger side headlight
Open the hood, take off the bumper (the placement consists of a few clips) and you have access to the headlight bolts. Unscrew those and you will remove the headlight.
You have to unbolt the entire soft bumper and remove. The dealer did this on my car to replace the headlight assembly.
there is 3 10 or llmm nuts on the back of the headlight assembly, then once that is removed there will be 4 torx screws that hold the headlight trim in place, once these are removed then bumper fillers can be installed.