Chevy Tahoe
Chevy Trucks and SUVs

How do you replace the OEM slave CD player in a 1999 Chevrolet Tahoe?

394041

Top Answer
User Avatar
Wiki User
2015-07-15 19:14:28
2015-07-15 19:14:28

Check with the dealer, or a salvage yard. Even one of the online auction sites.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Replacing the clutch slave cylinder requires removing the transmission assembly. I would recommend purchasing a shop repair manual for that vehicle if you intend on DIY.

User Avatar

How do you replace a slave cylinder in a 96 chevey k1500

User Avatar

How do you replace the clutch slave cylinder on a 1989 jeep wrangler

User Avatar

How do you replace a slave cylinder on a 1995 dodge neon clutch

User Avatar

HOW DO YOU REPLACE THE SLAVE CYLINDER ON A 1994 f 250 2 WHEEL DRIVE

User Avatar

The slave cylinder is usually replaced during a clutch replacement. The slave unit is fairly inexpensive but the labor can be costly since most vehicles require the transmission to be removed to replace the slave. Since the transmission has to be removed to replace the clutch anyway, there is no extra labor involved to replace the slave.

User Avatar

how to replace the slave cylinder on a 1993 jeep wrangler

User Avatar

to answer your question i need more info such as what type or model car is it and is it a clutch slave cylinder

User Avatar

Remove the transmission to excess the inturnal slave cylinder

User Avatar

No you don't have to drop the transmission in order to replace the slave cylinder, but be careful because it can easily be stripped.

User Avatar

if i replace slave cylinder in 1994 Honda civic ex will this make my clutch disengage and engage correctlyanswerchange master cylinder and slave properly then bleed the system properly.

User Avatar

Begin by removing the cover to your 1996 Chevy Suburban CD player. Remove the CD player retaining bolts. Remove the wiring harness from the back of the CD player. Reverse the process to install your new CD player.

User Avatar

You will need to remove the transmission to replace the clutch slave.

User Avatar

The transmission has to be removed to gain access to the clutch slave cylinder.

User Avatar

There are 4 slave cylinders on a truckPossibly type 1 is for a manual clutch and is in the Bell-housing for the clutch type 2 is the slave cylinder for the breaks and there is one for every wheel

User Avatar

I'm pretty sure that on that vehicle the slave cylinder is located inside the transmssion which means the transmission must be removed to replace it

User Avatar

You have to pull the tranny as it is located internally

User Avatar

You Must remove the trans to access the slave... on the 5 speed for sure.

User Avatar

remove 2 bolts holding it on,then replace, follow line back to bleeder valve,bleed,then bleed at slave cylinder

User Avatar

You will have to remove the transmission since the slave cylinder on the 91 yj is inside the bellhousing.

User Avatar

It depends on where the slave cylinder is located. If it is inside the bell housing you will have to remove the transmission.

User Avatar

If the problem has been getting worse over time than it is your clutch. If was sudden, then it is your slave cylinder. Also, the slave cylinder will usuall leak fluid when it is bad. If your not sure and nobody else is either, replace the slave first. It is farely cheap and super easy to replace. I hope this helps and good luck!

User Avatar

Yo have to remove the transmission.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.