Ford Escape
Ford Expedition
Ford Escape XLT

How do you replace the PCV valve on a 4 cylinder Ford Escape?

495051

Top Answer
User Avatar
Wiki User
2007-08-04 16:42:16
2007-08-04 16:42:16

PCV valve is located in the valve cover. start engine, allow to idle. disconnect pcv valve from valve cover and feel for vaccum. If you feel vaccum good, if not trouble shoot system. Pcv valve dirty, hose clogged or cracked, etc. check the rubber grommet in valve cover for deteriation, replace if necessary. if the old pcv valve is clogged the the hose may be as well, clean w/ solvent. install new valve and reconnect.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

How do you replace the EGR Valve on a 2001 Ford Escape?

User Avatar

The PCV valve on a 2005 Ford Escape 4 cylinder is located behind the alternator. It is under the intake manifold.

User Avatar

how do I set the timing on 2001 ford escape xlt 4 cylinder

User Avatar

The brake lines on a Ford Escape are replaced by removing the wheel, unscrewing the brake line at the wheel cylinder, and then at the distribution valve. New lines can then be set into place and screwed into the appropriate connector.

User Avatar

How to remove alternator on 2001 ford escape 4 cylinder

User Avatar

120,000 miles ( according to the scheduled maintainence guide ) for the 2.0 L - 4 cylinder engine in a 2004 Ford Escape

User Avatar

how to replace radiator in 2001 ford escape 3.0 engine

User Avatar

Both the 2.3 liter four cylinder engine and the 3.0 liter V6 engine in a 2007 Ford Escape have timing CHAINS

User Avatar

how do you replace left front seal on 2009 ford escape

User Avatar

video on how to replace parking brake cable in ford escape 2003

User Avatar

The 2.5 liter four cylinder engine in a 2010 Ford Escape has a timing CHAIN

User Avatar

( No ) the 2.5 litre four cylinder engine in a 2010 Ford Escape has a timing CHAIN

User Avatar

I have a 2007 ford escape, replaced a valve cover gasket in August 2012, noticed that i have a small oil leak around the gasket.

User Avatar

you can write on my e-mail adresse at sabristefs@hotmail.com

User Avatar

#1----#2----#3 #4----#5----#6 front of Ford Escape

User Avatar

how do you replace half shaft on 2992 ford escape

User Avatar

The brake valve is located next to the master brake cylinder. The valve can be found just below the master brake cylinder.

User Avatar

how to replace water pump in 93 ford econoline 6 cylinder ford van

User Avatar

( No ) the 2.3 liter Dual Over Head Cam , four cylinder engine in a 2006 Ford Escape has a timing CHAIN

User Avatar

where is the oil drain plug on a 2007 ford escape 4 cylinder

User Avatar

firewall #1----#2----#3 #4----#5----#6 front of Ford Escape

User Avatar

#1----#2----#3 #4----#5----#6 front of Ford Escape ( V6 engine )

User Avatar

how do you replace the alternator on a 2002 ford escape,without having to remove the the right side intermediate axle shaft?

User Avatar

Look on the back of your valve cover and you should find it.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.