git part...open hood.....disconect battery.........loosen bolt on back of alt..........loosen bolt holding tenson on alt ...........slide to loosen belts. should have 2 mine dose.......take wires off back of alt noticeing whare they go...........finish un bolting and remove..........reverse order to install new alt........use crow bar to git tension on belts..........is a easy job... have fun .........helli
no, probably not
The Dodge Dakota did not come out until 1987
how do i put a power steering pump on a 1987 dodge Dakota truck v6
replace 1987 dodge pickup/power window motor
A 1987 Dakota uses an expansion valve, not an orifice tube.A 1987 Dakota uses an expansion valve, not an orifice tube.
1987 to 1990 should be similar
In my 1989 Dodge Dakota the brake light is on fuse number13 it is a 5amp it also goes to buzzer, speed control, check engine light, anti-lock warning light, and other things page 12-19 Haynes 1987- 1993 Dodge Dakota Repair Manual
in a fuse block
under the hood near the wipers
Many vehicles have many more specifications added when the vehicle is produced. The towing capacity of a 1987 Dodge Dakota V6 is up to 5,500 pounds.Ê
Should be located in the back of the alternator
The timing marks on a 1987 2.2L Dodge Dakota are located on the timing chain and the cam sprocket. They must be perfectly aligned to prevent the pistons and valves from hitting each other.
Begin by removing the alternator belt. Remove the wiring harness from the back of your alternator. Remove the alternator retaining bolts. Reverse the process to install your new Cadillac alternator.
the ignition timing does not get replaced on 87 dodge.
The Dakota has been made since the first model year in 1987 an continues to be produced by Chrysler Corp.
Dodge Dakota currently still makes vehicles. The first generation of the Dakota was manufactured from 1987 until 1996. The second generation of Dakota vehicles manufactured were from 1997 until 2004. The third generation runs from 2005 until 2011.
In a service manual at a dealer, parts store, or library.
There was no Dakota until 1987,There was no Dakota until 1987,
IT would be possible, but it would be easier to buy a 1988 or newer Dakota and have it already equipped that way.
A ph3614 has a long list of applications including a 1987 Dodge Dakota truck.
usually, the regulator is located inside of the alternator.
from the furthest caliper from the master cylinder. Start with that one and move closer.
i have 235/75/15 on mine they are factory opicanal mot have that tho
On the block , Rear Passenger Side by Firewall , Left of the Distributor
You will need to loosen the alternator belt with the tensioner pulley. When the tensioner pulley is loose the alternator belt will become loose. Put the new alternator belt on and tighten the tensioner pulley.